[PATCH v4] video: mxsfb: Make sure axi clock is enabled when accessing registers

[PATCH v4] video: mxsfb: Make sure axi clock is enabled when accessing registers

[Liu Ying]

The LCDIF engines embedded in i.MX6sl and i.MX6sx SoCs need the axi clock
as the engine's system clock.  The clock should be enabled when accessing
LCDIF registers, otherwise the kernel would hang up.  We should also keep
the clock enabled when the engine is being active to scan out frames from
memory.  This patch makes sure the axi clock is enabled when accessing
registers so that the kernel hang up issue can be fixed.

Reported-by: Peter Chen <peter.chen@freescale.com>
Tested-by: Peter Chen <peter.chen@freescale.com>
Cc: <stable@vger.kernel.org> # 3.19+
Signed-off-by: Liu Ying <Ying.Liu@freescale.com>
---
v3->v4:
* To address Tomi's comment, enable/disable the axi clock in
  mxsfb_pan_display() directly instead of checking the host->enabled flag.

v2->v3:
* To address Tomi's comment, improve the commit message only.

v1->v2:
* Add 'Tested-by: Peter Chen <peter.chen@freescale.com>' tag.
* Add 'Cc: <stable@vger.kernel.org> # 3.19+' tag.

 drivers/video/fbdev/mxsfb.c | 68 +++++++++++++++++++++++++++++++++++----------
 1 file changed, 54 insertions(+), 14 deletions(-)

diff --git a/drivers/video/fbdev/mxsfb.c b/drivers/video/fbdev/mxsfb.c
index f8ac4a4..0f64165 100644
--- a/drivers/video/fbdev/mxsfb.c
+++ b/drivers/video/fbdev/mxsfb.c
@@ -316,6 +316,18 @@ static int mxsfb_check_var(struct fb_var_screeninfo *var,
 	return 0;
 }
 
+static inline void mxsfb_enable_axi_clk(struct mxsfb_info *host)
+{
+	if (host->clk_axi)
+		clk_prepare_enable(host->clk_axi);
+}
+
+static inline void mxsfb_disable_axi_clk(struct mxsfb_info *host)
+{
+	if (host->clk_axi)
+		clk_disable_unprepare(host->clk_axi);
+}
+
 static void mxsfb_enable_controller(struct fb_info *fb_info)
 {
 	struct mxsfb_info *host = to_imxfb_host(fb_info);
@@ -333,14 +345,13 @@ static void mxsfb_enable_controller(struct fb_info *fb_info)
 		}
 	}
 
-	if (host->clk_axi)
-		clk_prepare_enable(host->clk_axi);
-
 	if (host->clk_disp_axi)
 		clk_prepare_enable(host->clk_disp_axi);
 	clk_prepare_enable(host->clk);
 	clk_set_rate(host->clk, PICOS2KHZ(fb_info->var.pixclock) * 1000U);
 
+	mxsfb_enable_axi_clk(host);
+
 	/* if it was disabled, re-enable the mode again */
 	writel(CTRL_DOTCLK_MODE, host->base + LCDC_CTRL + REG_SET);
 
@@ -380,11 +391,11 @@ static void mxsfb_disable_controller(struct fb_info *fb_info)
 	reg = readl(host->base + LCDC_VDCTRL4);
 	writel(reg & ~VDCTRL4_SYNC_SIGNALS_ON, host->base + LCDC_VDCTRL4);
 
+	mxsfb_disable_axi_clk(host);
+
 	clk_disable_unprepare(host->clk);
 	if (host->clk_disp_axi)
 		clk_disable_unprepare(host->clk_disp_axi);
-	if (host->clk_axi)
-		clk_disable_unprepare(host->clk_axi);
 
 	host->enabled = 0;
 
@@ -421,6 +432,8 @@ static int mxsfb_set_par(struct fb_info *fb_info)
 		mxsfb_disable_controller(fb_info);
 	}
 
+	mxsfb_enable_axi_clk(host);
+
 	/* clear the FIFOs */
 	writel(CTRL1_FIFO_CLEAR, host->base + LCDC_CTRL1 + REG_SET);
 
@@ -438,6 +451,7 @@ static int mxsfb_set_par(struct fb_info *fb_info)
 		ctrl |= CTRL_SET_WORD_LENGTH(3);
 		switch (host->ld_intf_width) {
 		case STMLCDIF_8BIT:
+			mxsfb_disable_axi_clk(host);
 			dev_err(&host->pdev->dev,
 					"Unsupported LCD bus width mapping\n");
 			return -EINVAL;
@@ -451,6 +465,7 @@ static int mxsfb_set_par(struct fb_info *fb_info)
 		writel(CTRL1_SET_BYTE_PACKAGING(0x7), host->base + LCDC_CTRL1);
 		break;
 	default:
+		mxsfb_disable_axi_clk(host);
 		dev_err(&host->pdev->dev, "Unhandled color depth of %u\n",
 				fb_info->var.bits_per_pixel);
 		return -EINVAL;
@@ -504,6 +519,8 @@ static int mxsfb_set_par(struct fb_info *fb_info)
 			fb_info->fix.line_length * fb_info->var.yoffset,
 			host->base + host->devdata->next_buf);
 
+	mxsfb_disable_axi_clk(host);
+
 	if (reenable)
 		mxsfb_enable_controller(fb_info);
 
@@ -582,10 +599,14 @@ static int mxsfb_pan_display(struct fb_var_screeninfo *var,
 
 	offset = fb_info->fix.line_length * var->yoffset;
 
+	mxsfb_enable_axi_clk(host);
+
 	/* update on next VSYNC */
 	writel(fb_info->fix.smem_start + offset,
 			host->base + host->devdata->next_buf);
 
+	mxsfb_disable_axi_clk(host);
+
 	return 0;
 }
 
@@ -608,13 +629,17 @@ static int mxsfb_restore_mode(struct mxsfb_info *host,
 	unsigned line_count;
 	unsigned period;
 	unsigned long pa, fbsize;
-	int bits_per_pixel, ofs;
+	int bits_per_pixel, ofs, ret = 0;
 	u32 transfer_count, vdctrl0, vdctrl2, vdctrl3, vdctrl4, ctrl;
 
+	mxsfb_enable_axi_clk(host);
+
 	/* Only restore the mode when the controller is running */
 	ctrl = readl(host->base + LCDC_CTRL);
-	if (!(ctrl & CTRL_RUN))
-		return -EINVAL;
+	if (!(ctrl & CTRL_RUN)) {
+		ret = -EINVAL;
+		goto err;
+	}
 
 	vdctrl0 = readl(host->base + LCDC_VDCTRL0);
 	vdctrl2 = readl(host->base + LCDC_VDCTRL2);
@@ -635,7 +660,8 @@ static int mxsfb_restore_mode(struct mxsfb_info *host,
 		break;
 	case 1:
 	default:
-		return -EINVAL;
+		ret = -EINVAL;
+		goto err;
 	}
 
 	fb_info->var.bits_per_pixel = bits_per_pixel;
@@ -673,10 +699,14 @@ static int mxsfb_restore_mode(struct mxsfb_info *host,
 
 	pa = readl(host->base + host->devdata->cur_buf);
 	fbsize = fb_info->fix.line_length * vmode->yres;
-	if (pa < fb_info->fix.smem_start)
-		return -EINVAL;
-	if (pa + fbsize > fb_info->fix.smem_start + fb_info->fix.smem_len)
-		return -EINVAL;
+	if (pa < fb_info->fix.smem_start) {
+		ret = -EINVAL;
+		goto err;
+	}
+	if (pa + fbsize > fb_info->fix.smem_start + fb_info->fix.smem_len) {
+		ret = -EINVAL;
+		goto err;
+	}
 	ofs = pa - fb_info->fix.smem_start;
 	if (ofs) {
 		memmove(fb_info->screen_base, fb_info->screen_base + ofs, fbsize);
@@ -689,7 +719,11 @@ static int mxsfb_restore_mode(struct mxsfb_info *host,
 	clk_prepare_enable(host->clk);
 	host->enabled = 1;
 
-	return 0;
+err:
+	if (ret)
+		mxsfb_disable_axi_clk(host);
+
+	return ret;
 }
 
 static int mxsfb_init_fbinfo_dt(struct mxsfb_info *host,
@@ -915,7 +949,9 @@ static int mxsfb_probe(struct platform_device *pdev)
 	}
 
 	if (!host->enabled) {
+		mxsfb_enable_axi_clk(host);
 		writel(0, host->base + LCDC_CTRL);
+		mxsfb_disable_axi_clk(host);
 		mxsfb_set_par(fb_info);
 		mxsfb_enable_controller(fb_info);
 	}
@@ -954,11 +990,15 @@ static void mxsfb_shutdown(struct platform_device *pdev)
 	struct fb_info *fb_info = platform_get_drvdata(pdev);
 	struct mxsfb_info *host = to_imxfb_host(fb_info);
 
+	mxsfb_enable_axi_clk(host);
+
 	/*
 	 * Force stop the LCD controller as keeping it running during reboot
 	 * might interfere with the BootROM's boot mode pads sampling.
 	 */
 	writel(CTRL_RUN, host->base + LCDC_CTRL + REG_CLR);
+
+	mxsfb_disable_axi_clk(host);
 }
 
 static struct platform_driver mxsfb_driver = {
-- 
2.1.0

Re: [PATCH v4] video: mxsfb: Make sure axi clock is enabled when accessing registers

[Tomi Valkeinen]

[-- Attachment #1: Type: text/plain, Size: 1234 bytes --]

On 03/04/15 07:51, Liu Ying wrote:
> The LCDIF engines embedded in i.MX6sl and i.MX6sx SoCs need the axi clock
> as the engine's system clock.  The clock should be enabled when accessing
> LCDIF registers, otherwise the kernel would hang up.  We should also keep
> the clock enabled when the engine is being active to scan out frames from
> memory.  This patch makes sure the axi clock is enabled when accessing
> registers so that the kernel hang up issue can be fixed.
> 
> Reported-by: Peter Chen <peter.chen@freescale.com>
> Tested-by: Peter Chen <peter.chen@freescale.com>
> Cc: <stable@vger.kernel.org> # 3.19+
> Signed-off-by: Liu Ying <Ying.Liu@freescale.com>
> ---
> v3->v4:
> * To address Tomi's comment, enable/disable the axi clock in
>   mxsfb_pan_display() directly instead of checking the host->enabled flag.
> 
> v2->v3:
> * To address Tomi's comment, improve the commit message only.
> 
> v1->v2:
> * Add 'Tested-by: Peter Chen <peter.chen@freescale.com>' tag.
> * Add 'Cc: <stable@vger.kernel.org> # 3.19+' tag.
> 
>  drivers/video/fbdev/mxsfb.c | 68 +++++++++++++++++++++++++++++++++++----------
>  1 file changed, 54 insertions(+), 14 deletions(-)

Thanks, queued for 4.2.

 Tomi



[-- Attachment #2: OpenPGP digital signature --]
[-- Type: application/pgp-signature, Size: 819 bytes --]