Re: Suspend-resume failure on Intel Eagle Lake Core2Duo

[Marc Zyngier <marc.zyngier@arm.com>]

Hi Masahiro,

On 03/08/17 08:32, Masahiro Yamada wrote:
> Hi.
> 
> 2017-08-01 0:55 GMT+09:00 Thomas Gleixner <tglx@linutronix.de>:
>> On Mon, 31 Jul 2017, Tomi Sarvela wrote:
>>> On 31/07/17 18:06, Thomas Gleixner wrote:
>>>> Can you please remove the patch. And try the following:
>>>>
>>>> # echo N > /sys/module/printk/parameters/console_suspend
>>>>
>>>> # echo mem > /sys/power/state
>>>>
>>>> and log the output of the serial console. That way we might get a clue
>>>> where it gets stuck.
>>>
>>> I'm afraid it hangs right away. No response from SSH, no output to serial.
>>
>> What means hangs right away? Is there no output at all on the serial
>> console? Or does it just stop at some point?
>>
>> Thanks,
>>
>>         tglx
>>
> 
> Sorry for jumping in.
> Finally, I found this thread.
> 
> 
> My environment is completely different (ARM64 board),
> I am also suffering from a hibernation problem
> since this commit.
> 
> 
> I get no response on the serial console
> after "Restarting tasks ... done." log message.
> 
> 
> By reverting bf22ff45bed6 ("genirq: Avoid unnecessary low level
> irq function calls", I can get hibernation working again.
> 
> 
> SW info:
> defconfig:  arch/arm64/configs/defconfig
> DT       :  arch/arm64/boot/dts/socionext/uniphier-ld20-ref.dts
> PSCI     :  ARM Trusted Firmware
> 
> 
> SoC info:
> CPU      :  Cortex-A72 * 2 + Cortex-A53 * 2
> irqchip  :  GICv3 (drivers/irq/irq-gic-v3.c)

Let me take an educated guess: It feels like your firmware doesn't
save/restore the GIC context across suspend/resume. Is that something
you could check, assuming you have access to the firmware source code?

Thanks,

	M.
-- 
Jazz is not dead. It just smells funny...