netdev.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Ben Hutchings <bhutchings@solarflare.com>
To: Jim Baxter <jim_baxter@mentor.com>
Cc: "David S. Miller" <davem@davemloft.net>,
	Fabio Estevam <fabio.estevam@freescale.com>,
	Frank Li <Frank.Li@freescale.com>,
	Fugang Duan <B38611@freescale.com>, <netdev@vger.kernel.org>
Subject: Re: [PATCH net-next v4 1/1] net: fec: Enable imx6 enet checksum acceleration.
Date: Fri, 19 Apr 2013 17:20:17 +0100	[thread overview]
Message-ID: <1366388417.2716.6.camel@bwh-desktop.uk.solarflarecom.com> (raw)
In-Reply-To: <51716DE5.1070605@mentor.com>

On Fri, 2013-04-19 at 17:16 +0100, Jim Baxter wrote:
> On 19/04/13 16:34, Ben Hutchings wrote:
> > On Fri, 2013-04-19 at 16:10 +0100, Jim Baxter wrote:
> >> Enables hardware generation of IP header and
> >> protocol specific checksums for transmitted
> >> packets.
> >>
> >> Enabled hardware discarding of received packets with
> >> invalid IP header or protocol specific checksums.
> >>
> >> The feature is enabled by default but can be
> >> enabled/disabled by ethtool.
> >>
> >> Signed-off-by: Fugang Duan <B38611@freescale.com>
> >> Signed-off-by: Jim Baxter <jim_baxter@mentor.com>
> >> ---
> >>
> >> - Added IPV6 support.
> > [...]
> >> @@ -1439,6 +1496,14 @@ static int fec_enet_alloc_buffers(struct net_device *ndev)
> >>  		if (fep->bufdesc_ex) {
> >>  			struct bufdesc_ex *ebdp = (struct bufdesc_ex *)bdp;
> >>  			ebdp->cbd_esc = BD_ENET_TX_INT;
> >> +
> >> +			/* Enable protocol checksum flags
> >> +			 * We do not bother with the IP Checksum bits as they
> >> +			 * are done by the kernel
> >> +			 */
> >> +			if (ndev->features &
> >> +					(NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM))
> >> +				ebdp->cbd_esc |= BD_ENET_TX_PINS;
> >>  		}
> >>  
> >>  		bdp = fec_enet_get_nextdesc(bdp, fep->bufdesc_ex);
> > [...]
> > 
> > This condition needs to be based on skb->ip_summed.
> > 
> > Ben.
> > 
> 
> 
> These buffers are setup when the network driver is opened
> (fec_enet_open), with the same settings as the transmit buffers.
> 
> Thinking about it, they should probably not be set here and only set
> during the fec_enet_start_xmit() function.

Right.  Even when TX checksum offload is enabled, the kernel might not
want you to offload TX checksums for every packet.  For example, if your
interface is part of a bridge, packets should be forwarded even if they
have a bad layer-4 checksum on RX, and the checksum must not be
'corrected' on TX.

Ben.

-- 
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.

  reply	other threads:[~2013-04-19 16:20 UTC|newest]

Thread overview: 73+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
     [not found] <Jim Baxter <jim_baxter@mentor.com>
2013-04-17 20:07 ` [PATCH net-next v3 1/1] net: fec: Enable imx6 enet checksum acceleration Jim Baxter
2013-04-17 21:37   ` Eric Dumazet
2013-04-18 12:49     ` Jim Baxter
2013-04-18 16:16       ` Ben Hutchings
2013-04-18 17:07         ` Ben Hutchings
2013-04-18 17:08         ` Jim Baxter
2013-04-18 17:12           ` Ben Hutchings
2013-04-18 17:21             ` Jim Baxter
2013-04-18 21:27               ` Jim Baxter
2013-04-18 22:03                 ` Ben Hutchings
2013-04-17 22:45   ` Francois Romieu
2013-04-18 10:18     ` Jim Baxter
2013-04-18 11:31       ` Fabio Estevam
2013-04-18 21:54       ` Francois Romieu
2013-04-19  8:45         ` Jim Baxter
2013-04-19 15:10 ` [PATCH net-next v4 " Jim Baxter
2013-04-19 15:29   ` Eric Dumazet
2013-04-19 15:55     ` Jim Baxter
2013-04-19 15:56       ` Ben Hutchings
2013-04-19 15:59       ` Eric Dumazet
2013-04-19 15:34   ` Ben Hutchings
2013-04-19 16:16     ` Jim Baxter
2013-04-19 16:20       ` Ben Hutchings [this message]
2013-04-19 18:10 ` [PATCH net-next v5 " Jim Baxter
2013-04-19 18:50   ` Ben Hutchings
2013-04-25  7:59     ` David Miller
2013-06-25 23:55 ` [PATCH net-next v1 1/1] net: fec: Add VLAN receive HW support Jim Baxter
2013-06-26  2:22   ` Duan Fugang-B38611
2013-06-26  2:31   ` Duan Fugang-B38611
2013-06-26  2:56     ` Shawn Guo
2013-06-26  3:13       ` Duan Fugang-B38611
2013-06-26  5:49     ` David Miller
2013-06-26 10:09     ` Jim Baxter
2013-06-26 11:18       ` Duan Fugang-B38611
2013-06-26 11:45         ` Jim Baxter
2013-06-27  1:41           ` Duan Fugang-B38611
2013-06-27  9:35             ` Jim Baxter
2013-06-27  9:44           ` Lucas Stach
2013-06-27 14:03             ` Jim Baxter
2013-06-27 18:25 ` [PATCH net v1 1/1] net: fec: Fix Transmitted bytes counter Jim Baxter
2013-06-28  2:11   ` Duan Fugang-B38611
2013-07-01 20:40     ` David Miller
2013-07-02  8:32       ` Jim Baxter
2013-07-02  8:46         ` David Miller
2013-06-28  9:51 ` [PATCH net v2 " Jim Baxter
2013-06-28 10:10   ` Duan Fugang-B38611
2013-06-28 14:08 ` [PATCH net-next v2 1/1] net: fec: Add VLAN receive HW support Jim Baxter
2013-06-29  5:34   ` Duan Fugang-B38611
2013-07-02  0:09   ` David Miller
2013-07-02  9:39     ` Jim Baxter
2013-06-28 15:07 ` [PATCH RFC net-next v1 1/1] net: fec: Fix RMON registers on imx6 Jim Baxter
2013-06-29  5:58   ` Duan Fugang-B38611
     [not found]     ` <CAFXsbZpgAqvkEy+S83iJNMH9-N7h68MDRuvARE9pmT7HbcpAOQ@mail.gmail.com>
     [not found]       ` <CAFXsbZoBQ3ODUnFg-VumP+YAfCJ2-d=nL_=Gk2LKXm7PadHUuQ@mail.gmail.com>
2013-07-01 10:16         ` Jim Baxter
2013-07-01 10:31 ` [PATCH " Jim Baxter
     [not found]   ` <CAFXsbZoDWn4KgAVEpUtajo+PwfnrJoO0eTw9g6+MdQ8b666=EQ@mail.gmail.com>
2013-07-01 13:52     ` Jim Baxter
2013-07-02 19:41   ` David Miller
2013-07-01 13:57 ` [PATCH net-next v3 " Jim Baxter
2013-07-02 21:52 ` [PATCH net-next v3 1/1] net: fec: Add VLAN receive HW support Jim Baxter
2013-07-03 23:45   ` David Miller
2014-05-29 17:12 ` [PATCH v1 0/3] usb: gadget: NCM: Fixes and Multi-frame for TX Jim Baxter
2014-05-29 17:12   ` [PATCH v1 1/3] usb: gadget: NCM: RX function support multiple NDPs Jim Baxter
2014-05-29 18:55     ` Bjørn Mork
2014-05-30 11:45       ` Jim Baxter
2014-05-29 17:12   ` [PATCH v1 2/3] usb: gadget: NCM: Add transmit multi-frame Jim Baxter
2014-05-29 17:12   ` [PATCH v1 3/3] usb: gadget: NCM: Stop RX TCP Bursts getting dropped Jim Baxter
2014-05-29 19:04     ` Eric Dumazet
2014-05-30 11:25       ` Jim Baxter
2014-06-12  9:38         ` Jim Baxter
2014-06-12  9:42           ` David Laight
2014-07-07 17:33 ` [PATCH v2 0/3] usb: gadget: NCM: Fixes and Multi-frame for TX Jim Baxter
2014-07-07 17:33   ` [PATCH v2 1/3] usb: gadget: NCM: RX function support multiple NDPs Jim Baxter
2014-07-07 17:33   ` [PATCH v2 2/3] usb: gadget: NCM: Add transmit multi-frame Jim Baxter
2014-07-07 17:33   ` [PATCH v2 3/3] usb: gadget: NCM: Stop RX TCP Bursts getting dropped Jim Baxter

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1366388417.2716.6.camel@bwh-desktop.uk.solarflarecom.com \
    --to=bhutchings@solarflare.com \
    --cc=B38611@freescale.com \
    --cc=Frank.Li@freescale.com \
    --cc=davem@davemloft.net \
    --cc=fabio.estevam@freescale.com \
    --cc=jim_baxter@mentor.com \
    --cc=netdev@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).