From: Ansuel Smith <ansuelsmth@gmail.com>
To: Florian Fainelli <f.fainelli@gmail.com>
Cc: Ansuel Smith <ansuelsmth@gmail.com>, Andrew Lunn <andrew@lunn.ch>,
Vivien Didelot <vivien.didelot@gmail.com>,
Vladimir Oltean <olteanv@gmail.com>,
"David S. Miller" <davem@davemloft.net>,
Jakub Kicinski <kuba@kernel.org>,
Russell King <linux@armlinux.org.uk>,
netdev@vger.kernel.org, linux-kernel@vger.kernel.org
Subject: [RFC PATCH net-next v3 12/20] net: dsa: qca8k: add support for switch rev
Date: Wed, 5 May 2021 00:29:06 +0200 [thread overview]
Message-ID: <20210504222915.17206-12-ansuelsmth@gmail.com> (raw)
In-Reply-To: <20210504222915.17206-1-ansuelsmth@gmail.com>
qca8k internal phy driver require some special debug value to be set
based on the switch revision. Rework the switch id read function to
also read the chip revision.
Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
---
drivers/net/dsa/qca8k.c | 50 ++++++++++++++++++++++++++---------------
drivers/net/dsa/qca8k.h | 6 +++--
2 files changed, 36 insertions(+), 20 deletions(-)
diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
index ce3606d8e6a4..22334d416f53 100644
--- a/drivers/net/dsa/qca8k.c
+++ b/drivers/net/dsa/qca8k.c
@@ -1586,12 +1586,38 @@ static const struct dsa_switch_ops qca8k_switch_ops = {
.phylink_mac_link_up = qca8k_phylink_mac_link_up,
};
+static int qca8k_read_switch_id(struct qca8k_priv *priv)
+{
+ const struct qca8k_match_data *data;
+ u32 val;
+ u8 id;
+
+ /* get the switches ID from the compatible */
+ data = of_device_get_match_data(priv->dev);
+ if (!data)
+ return -ENODEV;
+
+ val = qca8k_read(priv, QCA8K_REG_MASK_CTRL);
+ if (val < 0)
+ return -ENODEV;
+
+ id = QCA8K_MASK_CTRL_DEVICE_ID(val & QCA8K_MASK_CTRL_DEVICE_ID_MASK);
+ if (id != data->id) {
+ dev_err(priv->dev, "Switch id detected %x but expected %x", id, data->id);
+ return -ENODEV;
+ }
+
+ /* Save revision to communicate to the internal PHY driver */
+ priv->switch_revision = (val & QCA8K_MASK_CTRL_REV_ID_MASK);
+
+ return 0;
+}
+
static int
qca8k_sw_probe(struct mdio_device *mdiodev)
{
- const struct qca8k_match_data *data;
struct qca8k_priv *priv;
- u32 id;
+ int ret;
/* allocate the private data struct so that we can probe the switches
* ID register
@@ -1617,22 +1643,10 @@ qca8k_sw_probe(struct mdio_device *mdiodev)
gpiod_set_value_cansleep(priv->reset_gpio, 0);
}
- /* get the switches ID from the compatible */
- data = of_device_get_match_data(&mdiodev->dev);
- if (!data)
- return -ENODEV;
-
- /* read the switches ID register */
- id = qca8k_read(priv, QCA8K_REG_MASK_CTRL);
- if (id < 0)
- return id;
-
- id >>= QCA8K_MASK_CTRL_ID_S;
- id &= QCA8K_MASK_CTRL_ID_M;
- if (id != data->id) {
- dev_err(&mdiodev->dev, "Switch id detected %x but expected %x", id, data->id);
- return -ENODEV;
- }
+ /* Check the detected switch id */
+ ret = qca8k_read_switch_id(priv);
+ if (ret)
+ return ret;
priv->ds = devm_kzalloc(&mdiodev->dev, sizeof(*priv->ds), GFP_KERNEL);
if (!priv->ds)
diff --git a/drivers/net/dsa/qca8k.h b/drivers/net/dsa/qca8k.h
index 5fb68dbfa85a..0b503f78bf92 100644
--- a/drivers/net/dsa/qca8k.h
+++ b/drivers/net/dsa/qca8k.h
@@ -28,8 +28,10 @@
/* Global control registers */
#define QCA8K_REG_MASK_CTRL 0x000
-#define QCA8K_MASK_CTRL_ID_M 0xff
-#define QCA8K_MASK_CTRL_ID_S 8
+#define QCA8K_MASK_CTRL_REV_ID_MASK GENMASK(7, 0)
+#define QCA8K_MASK_CTRL_REV_ID(x) ((x) >> 0)
+#define QCA8K_MASK_CTRL_DEVICE_ID_MASK GENMASK(15, 8)
+#define QCA8K_MASK_CTRL_DEVICE_ID(x) ((x) >> 8)
#define QCA8K_REG_PORT0_PAD_CTRL 0x004
#define QCA8K_REG_PORT5_PAD_CTRL 0x008
#define QCA8K_REG_PORT6_PAD_CTRL 0x00c
--
2.30.2
next prev parent reply other threads:[~2021-05-04 22:30 UTC|newest]
Thread overview: 59+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-05-04 22:28 [RFC PATCH net-next v3 01/20] net: mdio: ipq8064: clean whitespaces in define Ansuel Smith
2021-05-04 22:28 ` [RFC PATCH net-next v3 02/20] net: mdio: ipq8064: add regmap config to disable REGCACHE Ansuel Smith
2021-05-04 22:28 ` [RFC PATCH net-next v3 03/20] net: mdio: ipq8064: enlarge sleep after read/write operation Ansuel Smith
2021-05-04 22:28 ` [RFC PATCH net-next v3 04/20] net: dsa: qca8k: handle qca8k_set_page errors Ansuel Smith
2021-05-05 0:25 ` Andrew Lunn
2021-05-05 0:26 ` Andrew Lunn
2021-05-04 22:28 ` [RFC PATCH net-next v3 05/20] net: dsa: qca8k: handle error with qca8k_read operation Ansuel Smith
2021-05-05 0:36 ` Andrew Lunn
2021-05-05 0:44 ` Ansuel Smith
2021-05-04 22:29 ` [RFC PATCH net-next v3 06/20] net: dsa: qca8k: handle error with qca8k_write operation Ansuel Smith
2021-05-05 0:41 ` Andrew Lunn
2021-05-05 0:47 ` Ansuel Smith
2021-05-06 11:19 ` Vladimir Oltean
2021-05-04 22:29 ` [RFC PATCH net-next v3 07/20] net: dsa: qca8k: handle error with qca8k_rmw operation Ansuel Smith
2021-05-05 0:46 ` Andrew Lunn
2021-05-05 0:51 ` Ansuel Smith
2021-05-04 22:29 ` [RFC PATCH net-next v3 08/20] net: dsa: qca8k: add support for qca8327 switch Ansuel Smith
2021-05-05 0:48 ` Andrew Lunn
2021-05-06 11:20 ` Vladimir Oltean
2021-05-04 22:29 ` [RFC PATCH net-next v3 09/20] devicetree: net: dsa: qca8k: Document new compatible qca8327 Ansuel Smith
2021-05-05 0:48 ` Andrew Lunn
2021-05-06 21:07 ` Rob Herring
2021-05-04 22:29 ` [RFC PATCH net-next v3 10/20] net: dsa: qca8k: add priority tweak to qca8337 switch Ansuel Smith
2021-05-05 0:53 ` Andrew Lunn
2021-05-06 11:16 ` Vladimir Oltean
2021-05-04 22:29 ` [RFC PATCH net-next v3 11/20] net: dsa: qca8k: add GLOBAL_FC settings needed for qca8327 Ansuel Smith
2021-05-05 0:54 ` Andrew Lunn
2021-05-04 22:29 ` Ansuel Smith [this message]
2021-05-04 22:29 ` [RFC PATCH net-next v3 13/20] net: dsa: qca8k: make rgmii delay configurable Ansuel Smith
2021-05-05 1:00 ` Andrew Lunn
2021-05-05 1:07 ` Ansuel Smith
2021-05-06 11:10 ` Vladimir Oltean
2021-05-06 21:53 ` Ansuel Smith
2021-05-07 8:51 ` Vladimir Oltean
2021-05-04 22:29 ` [RFC PATCH net-next v3 14/20] net: dsa: qca8k: clear MASTER_EN after phy read/write Ansuel Smith
2021-05-04 22:29 ` [RFC PATCH net-next v3 15/20] net: dsa: qca8k: dsa: qca8k: protect MASTER busy_wait with mdio mutex Ansuel Smith
2021-05-05 1:04 ` Andrew Lunn
2021-05-04 22:29 ` [RFC PATCH net-next v3 16/20] net: dsa: qca8k: enlarge mdio delay and timeout Ansuel Smith
2021-05-06 11:27 ` Vladimir Oltean
2021-05-04 22:29 ` [RFC PATCH net-next v3 17/20] net: phy: phylink: permit to pass dev_flags to phylink_connect_phy Ansuel Smith
2021-05-04 22:33 ` Florian Fainelli
2021-05-05 0:35 ` Ansuel Smith
2021-05-04 22:29 ` [RFC PATCH net-next v3 18/20] net: dsa: slave: pass dev_flags also to internal PHY Ansuel Smith
2021-05-04 22:29 ` [RFC PATCH net-next v3 19/20] net: dsa: qca8k: pass switch_revision info to phy dev_flags Ansuel Smith
2021-05-06 11:24 ` Vladimir Oltean
2021-05-07 23:26 ` Ansuel Smith
2021-05-07 23:33 ` Russell King - ARM Linux admin
2021-05-07 23:51 ` Ansuel Smith
2021-05-08 17:31 ` Andrew Lunn
2021-05-08 18:26 ` Vladimir Oltean
2021-05-08 19:39 ` Russell King - ARM Linux admin
2021-05-08 20:55 ` Andrew Lunn
2021-05-07 9:44 ` Russell King - ARM Linux admin
2021-05-04 22:29 ` [RFC PATCH net-next v3 20/20] net: phy: add qca8k driver for qca8k switch internal PHY Ansuel Smith
2021-05-05 1:11 ` Andrew Lunn
2021-05-05 1:17 ` Ansuel Smith
2021-05-05 12:06 ` Andrew Lunn
2021-05-04 22:29 ` [RFC PATCH next-next v3 00/20] Multiple improvement to qca8k stability Ansuel Smith
2021-05-05 0:17 ` [RFC PATCH net-next v3 01/20] net: mdio: ipq8064: clean whitespaces in define Andrew Lunn
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20210504222915.17206-12-ansuelsmth@gmail.com \
--to=ansuelsmth@gmail.com \
--cc=andrew@lunn.ch \
--cc=davem@davemloft.net \
--cc=f.fainelli@gmail.com \
--cc=kuba@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@armlinux.org.uk \
--cc=netdev@vger.kernel.org \
--cc=olteanv@gmail.com \
--cc=vivien.didelot@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).