From: Archit Taneja <architt@codeaurora.org>
To: dri-devel@lists.freedesktop.org, robdclark@gmail.com
Cc: linux-arm-msm@vger.kernel.org, Archit Taneja <architt@codeaurora.org>
Subject: [PATCH v2 10/10] dt-bindings: Add DSIv2 documentation
Date: Wed, 18 Nov 2015 16:25:31 +0530 [thread overview]
Message-ID: <1447844131-4182-11-git-send-email-architt@codeaurora.org> (raw)
In-Reply-To: <1447844131-4182-1-git-send-email-architt@codeaurora.org>
Add additional property info needed for DSIv2 DT.
Signed-off-by: Archit Taneja <architt@codeaurora.org>
---
Documentation/devicetree/bindings/display/msm/dsi.txt | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/display/msm/dsi.txt b/Documentation/devicetree/bindings/display/msm/dsi.txt
index f344b9e..ca65a34 100644
--- a/Documentation/devicetree/bindings/display/msm/dsi.txt
+++ b/Documentation/devicetree/bindings/display/msm/dsi.txt
@@ -13,18 +13,25 @@ Required properties:
- power-domains: Should be <&mmcc MDSS_GDSC>.
- clocks: device clocks
See Documentation/devicetree/bindings/clocks/clock-bindings.txt for details.
-- clock-names: the following clocks are required:
+- clock-names: these vary based on the DSI version. For DSI6G:
* "bus_clk"
* "byte_clk"
+ * "byte_clk_src
* "core_clk"
* "core_mmss_clk"
* "iface_clk"
* "mdp_core_clk"
* "pixel_clk"
+ * "pixel_clk_src"
+ For DSIv2, we need a few more:
+ * "dsi_clk_src"
+ * "esc_clk_src"
+ * "src_clk"
- vdd-supply: phandle to vdd regulator device node
- vddio-supply: phandle to vdd-io regulator device node
- vdda-supply: phandle to vdda regulator device node
- qcom,dsi-phy: phandle to DSI PHY device node
+- syscon-sfpb: A phandle to mmss_sfpb syscon node (only for DSIv2)
Optional properties:
- panel@0: Node of panel connected to this DSI controller.
@@ -51,6 +58,7 @@ Required properties:
* "qcom,dsi-phy-28nm-hpm"
* "qcom,dsi-phy-28nm-lp"
* "qcom,dsi-phy-20nm"
+ * "qcom,dsi-phy-28nm-8960"
- reg: Physical base address and length of the registers of PLL, PHY and PHY
regulator
- reg-names: The names of register regions. The following regions are required:
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation
next prev parent reply other threads:[~2015-11-18 10:56 UTC|newest]
Thread overview: 52+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-10-14 12:58 [PATCH 00/12] drm/msm/dsi: Add support for DSI on MSM8960/APQ8064 Archit Taneja
2015-10-14 12:58 ` [PATCH 01/12] drm/msm/dsi: Update generated header for 8960 Archit Taneja
2015-10-14 12:58 ` [PATCH 02/12] drm/msm/dsi: Add support for 28nm PHY on 8960 Archit Taneja
2015-10-14 12:58 ` [PATCH 03/12] drm/msm/dsi: Add DSI PLL for 28nm 8960 PHY Archit Taneja
2015-10-14 20:35 ` Stephen Boyd
2015-10-16 13:08 ` Archit Taneja
2015-10-16 18:28 ` Stephen Boyd
2015-10-14 12:58 ` [PATCH 04/12] drm/msm/dsi: Use a better way to figure out DSI version Archit Taneja
2015-10-14 12:58 ` [PATCH 05/12] drm/msm/dsi: Delay dsi_clk_init Archit Taneja
2015-10-14 12:58 ` [PATCH 06/12] drm/msm/dsi: Parse bus clocks from a list Archit Taneja
2015-10-14 12:58 ` [PATCH 07/12] drm/msm/dsi: Set up link clocks for DSIv2 Archit Taneja
2015-10-14 12:59 ` [PATCH 08/12] drm/msm/dsi: Add dsi_cfg for APQ8064 Archit Taneja
2015-10-14 12:59 ` [PATCH 09/12] drm/msm/dsi: Don't use iommu for command TX buffer for DSIv2 Archit Taneja
2015-10-14 12:59 ` [PATCH 10/12] drm/msm/dsi: SFPB: Update generated headers Archit Taneja
2015-10-14 12:59 ` [PATCH 11/12] drm/msm/dsi: Enable MMSS SPFB port via syscon Archit Taneja
2015-10-14 12:59 ` [PATCH 12/12] dt-bindings: Add DSIv2 documentation Archit Taneja
2015-11-18 10:55 ` [PATCH v2 00/10] drm/msm/dsi: Add support for DSI on MSM8960/APQ8064 Archit Taneja
2015-11-18 10:55 ` [PATCH v2 01/10] drm/msm/dsi: Add support for 28nm PHY on 8960 Archit Taneja
2015-11-18 10:55 ` [PATCH v2 02/10] drm/msm/dsi: Add DSI PLL for 28nm 8960 PHY Archit Taneja
2015-11-18 10:55 ` [PATCH v2 03/10] drm/msm/dsi: Use a better way to figure out DSI version Archit Taneja
2015-11-18 10:55 ` [PATCH v2 04/10] drm/msm/dsi: Delay dsi_clk_init Archit Taneja
2015-11-18 10:55 ` [PATCH v2 05/10] drm/msm/dsi: Parse bus clocks from a list Archit Taneja
2015-11-18 10:55 ` [PATCH v2 06/10] drm/msm/dsi: Set up link clocks for DSIv2 Archit Taneja
2015-11-18 10:55 ` [PATCH v2 07/10] drm/msm/dsi: Add dsi_cfg for APQ8064 Archit Taneja
2015-11-18 10:55 ` [PATCH v2 08/10] drm/msm/dsi: Don't use iommu for command TX buffer for DSIv2 Archit Taneja
2015-11-18 10:55 ` [PATCH v2 09/10] drm/msm/dsi: Enable MMSS SPFB port via syscon Archit Taneja
2015-11-18 10:55 ` Archit Taneja [this message]
2015-11-18 13:18 ` [PATCH v2 10/10] dt-bindings: Add DSIv2 documentation Rob Herring
2015-11-18 15:24 ` Archit Taneja
[not found] ` <564C981F.3040907-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2015-11-20 19:59 ` Rob Herring
2015-11-23 6:13 ` Archit Taneja
2015-12-02 8:20 ` Stephen Boyd
2015-12-02 8:34 ` Stephen Boyd
2015-12-07 6:51 ` Archit Taneja
2015-12-02 9:56 ` Archit Taneja
2015-12-03 7:16 ` Stephen Boyd
2015-12-03 11:11 ` Archit Taneja
2015-12-01 9:59 ` [PATCH v3 00/12] drm/msm/dsi: Add support for DSI on MSM8960/APQ8064 Archit Taneja
2015-12-01 9:59 ` [PATCH v3 01/12] drm/msm/dsi: Don't get byte/pixel source clocks from DT Archit Taneja
2015-12-01 10:00 ` [PATCH v3 02/12] drm/msm/dsi: Add support for 28nm PHY on 8960 Archit Taneja
2015-12-01 10:00 ` [PATCH v3 03/12] drm/msm/dsi: Add DSI PLL for 28nm 8960 PHY Archit Taneja
2015-12-01 10:00 ` [PATCH v3 04/12] drm/msm/dsi: Use a better way to figure out DSI version Archit Taneja
2015-12-01 10:00 ` [PATCH v3 05/12] drm/msm/dsi: Delay dsi_clk_init Archit Taneja
2015-12-01 10:00 ` [PATCH v3 06/12] drm/msm/dsi: Parse bus clocks from a list Archit Taneja
2015-12-01 10:00 ` [PATCH v3 07/12] drm/msm/dsi: Set up link clocks for DSIv2 Archit Taneja
2015-12-01 10:00 ` [PATCH v3 08/12] drm/msm/dsi: Add dsi_cfg for APQ8064 Archit Taneja
2015-12-01 10:00 ` [PATCH v3 09/12] drm/msm/dsi: Don't use iommu for command TX buffer for DSIv2 Archit Taneja
2015-12-01 10:00 ` [PATCH v3 10/12] drm/msm/dsi: Enable MMSS SPFB port via syscon Archit Taneja
2015-12-01 10:00 ` [PATCH v3 11/12] dt-bindings: msm/dsi: Fix the order in which clocks are listed Archit Taneja
2015-12-04 14:45 ` Rob Herring
2015-12-01 10:00 ` [PATCH v3 12/12] dt-bindings: msm/dsi: Add DSIv2 documentation Archit Taneja
2015-12-04 14:46 ` Rob Herring
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1447844131-4182-11-git-send-email-architt@codeaurora.org \
--to=architt@codeaurora.org \
--cc=dri-devel@lists.freedesktop.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=robdclark@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.