From: Kalle Valo <kvalo@kernel.org> To: ath11k@lists.infradead.org Cc: linux-wireless@vger.kernel.org Subject: [PATCH 1/2] ath11k: pci: fix crash on suspend if board file is not found Date: Thu, 27 Jan 2022 11:01:16 +0200 [thread overview] Message-ID: <20220127090117.2024-1-kvalo@kernel.org> (raw) From: Kalle Valo <quic_kvalo@quicinc.com> Mario reported that the kernel was crashing on suspend if ath11k was not able to find a board file: [ 473.693286] PM: Suspending system (s2idle) [ 473.693291] printk: Suspending console(s) (use no_console_suspend to debug) [ 474.407787] BUG: unable to handle page fault for address: 0000000000002070 [ 474.407791] #PF: supervisor read access in kernel mode [ 474.407794] #PF: error_code(0x0000) - not-present page [ 474.407798] PGD 0 P4D 0 [ 474.407801] Oops: 0000 [#1] PREEMPT SMP NOPTI [ 474.407805] CPU: 2 PID: 2350 Comm: kworker/u32:14 Tainted: G W 5.16.0 #248 [...] [ 474.407868] Call Trace: [ 474.407870] <TASK> [ 474.407874] ? _raw_spin_lock_irqsave+0x2a/0x60 [ 474.407882] ? lock_timer_base+0x72/0xa0 [ 474.407889] ? _raw_spin_unlock_irqrestore+0x29/0x3d [ 474.407892] ? try_to_del_timer_sync+0x54/0x80 [ 474.407896] ath11k_dp_rx_pktlog_stop+0x49/0xc0 [ath11k] [ 474.407912] ath11k_core_suspend+0x34/0x130 [ath11k] [ 474.407923] ath11k_pci_pm_suspend+0x1b/0x50 [ath11k_pci] [ 474.407928] pci_pm_suspend+0x7e/0x170 [ 474.407935] ? pci_pm_freeze+0xc0/0xc0 [ 474.407939] dpm_run_callback+0x4e/0x150 [ 474.407947] __device_suspend+0x148/0x4c0 [ 474.407951] async_suspend+0x20/0x90 dmesg-efi-164255130401001: Oops#1 Part1 [ 474.407955] async_run_entry_fn+0x33/0x120 [ 474.407959] process_one_work+0x220/0x3f0 [ 474.407966] worker_thread+0x4a/0x3d0 [ 474.407971] kthread+0x17a/0x1a0 [ 474.407975] ? process_one_work+0x3f0/0x3f0 [ 474.407979] ? set_kthread_struct+0x40/0x40 [ 474.407983] ret_from_fork+0x22/0x30 [ 474.407991] </TASK> The issue here is that board file loading happens after ath11k_pci_probe() succesfully returns (ath11k initialisation happends asynchronously) and the suspend handler is still enabled, of course failing as ath11k is not properly initialised. Fix this by checking ATH11K_FLAG_QMI_FAIL during both suspend and resume. Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03003-QCAHSPSWPL_V1_V2_SILICONZ_LITE-2 Reported-by: Mario Limonciello <mario.limonciello@amd.com> Link: https://bugzilla.kernel.org/show_bug.cgi?id=215504 Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com> --- drivers/net/wireless/ath/ath11k/pci.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/net/wireless/ath/ath11k/pci.c b/drivers/net/wireless/ath/ath11k/pci.c index d73b522a0081..16a3560cfaf8 100644 --- a/drivers/net/wireless/ath/ath11k/pci.c +++ b/drivers/net/wireless/ath/ath11k/pci.c @@ -1571,6 +1571,11 @@ static __maybe_unused int ath11k_pci_pm_suspend(struct device *dev) struct ath11k_base *ab = dev_get_drvdata(dev); int ret; + if (test_bit(ATH11K_FLAG_QMI_FAIL, &ab->dev_flags)) { + ath11k_dbg(ab, ATH11K_DBG_BOOT, "boot skipping pci suspend as qmi is not initialised\n"); + return 0; + } + ret = ath11k_core_suspend(ab); if (ret) ath11k_warn(ab, "failed to suspend core: %d\n", ret); @@ -1583,6 +1588,11 @@ static __maybe_unused int ath11k_pci_pm_resume(struct device *dev) struct ath11k_base *ab = dev_get_drvdata(dev); int ret; + if (test_bit(ATH11K_FLAG_QMI_FAIL, &ab->dev_flags)) { + ath11k_dbg(ab, ATH11K_DBG_BOOT, "boot skipping pci resume as qmi is not initialised\n"); + return 0; + } + ret = ath11k_core_resume(ab); if (ret) ath11k_warn(ab, "failed to resume core: %d\n", ret); -- 2.20.1
WARNING: multiple messages have this Message-ID (diff)
From: Kalle Valo <kvalo@kernel.org> To: ath11k@lists.infradead.org Cc: linux-wireless@vger.kernel.org Subject: [PATCH 1/2] ath11k: pci: fix crash on suspend if board file is not found Date: Thu, 27 Jan 2022 11:01:16 +0200 [thread overview] Message-ID: <20220127090117.2024-1-kvalo@kernel.org> (raw) From: Kalle Valo <quic_kvalo@quicinc.com> Mario reported that the kernel was crashing on suspend if ath11k was not able to find a board file: [ 473.693286] PM: Suspending system (s2idle) [ 473.693291] printk: Suspending console(s) (use no_console_suspend to debug) [ 474.407787] BUG: unable to handle page fault for address: 0000000000002070 [ 474.407791] #PF: supervisor read access in kernel mode [ 474.407794] #PF: error_code(0x0000) - not-present page [ 474.407798] PGD 0 P4D 0 [ 474.407801] Oops: 0000 [#1] PREEMPT SMP NOPTI [ 474.407805] CPU: 2 PID: 2350 Comm: kworker/u32:14 Tainted: G W 5.16.0 #248 [...] [ 474.407868] Call Trace: [ 474.407870] <TASK> [ 474.407874] ? _raw_spin_lock_irqsave+0x2a/0x60 [ 474.407882] ? lock_timer_base+0x72/0xa0 [ 474.407889] ? _raw_spin_unlock_irqrestore+0x29/0x3d [ 474.407892] ? try_to_del_timer_sync+0x54/0x80 [ 474.407896] ath11k_dp_rx_pktlog_stop+0x49/0xc0 [ath11k] [ 474.407912] ath11k_core_suspend+0x34/0x130 [ath11k] [ 474.407923] ath11k_pci_pm_suspend+0x1b/0x50 [ath11k_pci] [ 474.407928] pci_pm_suspend+0x7e/0x170 [ 474.407935] ? pci_pm_freeze+0xc0/0xc0 [ 474.407939] dpm_run_callback+0x4e/0x150 [ 474.407947] __device_suspend+0x148/0x4c0 [ 474.407951] async_suspend+0x20/0x90 dmesg-efi-164255130401001: Oops#1 Part1 [ 474.407955] async_run_entry_fn+0x33/0x120 [ 474.407959] process_one_work+0x220/0x3f0 [ 474.407966] worker_thread+0x4a/0x3d0 [ 474.407971] kthread+0x17a/0x1a0 [ 474.407975] ? process_one_work+0x3f0/0x3f0 [ 474.407979] ? set_kthread_struct+0x40/0x40 [ 474.407983] ret_from_fork+0x22/0x30 [ 474.407991] </TASK> The issue here is that board file loading happens after ath11k_pci_probe() succesfully returns (ath11k initialisation happends asynchronously) and the suspend handler is still enabled, of course failing as ath11k is not properly initialised. Fix this by checking ATH11K_FLAG_QMI_FAIL during both suspend and resume. Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03003-QCAHSPSWPL_V1_V2_SILICONZ_LITE-2 Reported-by: Mario Limonciello <mario.limonciello@amd.com> Link: https://bugzilla.kernel.org/show_bug.cgi?id=215504 Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com> --- drivers/net/wireless/ath/ath11k/pci.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/net/wireless/ath/ath11k/pci.c b/drivers/net/wireless/ath/ath11k/pci.c index d73b522a0081..16a3560cfaf8 100644 --- a/drivers/net/wireless/ath/ath11k/pci.c +++ b/drivers/net/wireless/ath/ath11k/pci.c @@ -1571,6 +1571,11 @@ static __maybe_unused int ath11k_pci_pm_suspend(struct device *dev) struct ath11k_base *ab = dev_get_drvdata(dev); int ret; + if (test_bit(ATH11K_FLAG_QMI_FAIL, &ab->dev_flags)) { + ath11k_dbg(ab, ATH11K_DBG_BOOT, "boot skipping pci suspend as qmi is not initialised\n"); + return 0; + } + ret = ath11k_core_suspend(ab); if (ret) ath11k_warn(ab, "failed to suspend core: %d\n", ret); @@ -1583,6 +1588,11 @@ static __maybe_unused int ath11k_pci_pm_resume(struct device *dev) struct ath11k_base *ab = dev_get_drvdata(dev); int ret; + if (test_bit(ATH11K_FLAG_QMI_FAIL, &ab->dev_flags)) { + ath11k_dbg(ab, ATH11K_DBG_BOOT, "boot skipping pci resume as qmi is not initialised\n"); + return 0; + } + ret = ath11k_core_resume(ab); if (ret) ath11k_warn(ab, "failed to resume core: %d\n", ret); -- 2.20.1 -- ath11k mailing list ath11k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath11k
next reply other threads:[~2022-01-27 9:01 UTC|newest] Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top 2022-01-27 9:01 Kalle Valo [this message] 2022-01-27 9:01 ` [PATCH 1/2] ath11k: pci: fix crash on suspend if board file is not found Kalle Valo 2022-01-27 9:01 ` [PATCH 2/2] ath11k: mhi: use mhi_sync_power_up() Kalle Valo 2022-01-27 9:01 ` Kalle Valo 2022-01-27 23:36 ` Jeff Johnson 2022-01-28 9:06 ` Kalle Valo 2022-01-31 14:11 ` [PATCH 1/2] ath11k: pci: fix crash on suspend if board file is not found Kalle Valo 2022-01-31 14:11 ` Kalle Valo
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20220127090117.2024-1-kvalo@kernel.org \ --to=kvalo@kernel.org \ --cc=ath11k@lists.infradead.org \ --cc=linux-wireless@vger.kernel.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.