From: Vignesh R <vigneshr@ti.com> To: Sebastian Andrzej Siewior <bigeasy@linutronix.de>, "Griffis, Brad" <bgriffis@ti.com>, Rob Herring <robh+dt@kernel.org>, Pawel Moll <pawel.moll@arm.com>, Mark Rutland <mark.rutland@arm.com>, Ian Campbell <ijc+devicetree@hellion.org.uk>, Kumar Gala <galak@codeaurora.org>, Benoit Cousson <bcousson@baylibre.com>, Tony Lindgren <tony@atomide.com>, Russell King <linux@arm.linux.org.uk>, Jonathan Cameron <jic23@kernel.org>, Dmitry Torokhov <dmitry.torokhov@gmail.com> Cc: Hartmut Knaack <knaack.h@gmx.de>, Lars-Peter Clausen <lars@metafoo.de>, Peter Meerwald <pmeerw@pmeerw.net>, Samuel Ortiz <sameo@linux.intel.com>, Lee Jones <lee.jones@linaro.org>, "Balbi, Felipe" <balbi@ti.com>, Jan Kardell <jan.kardell@telliq.com>, Paul Gortmaker <paul.gortmaker@windriver.com>, "devicetree@vger.kernel.org" <devicetree@vger.kernel.org>, "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>, "linux-omap@vger.kernel.org" <linux-omap@vger.kernel.org>, "linux-arm-kernel@lists.infradead.org" <linux-arm-kernel@lists.infradead.org>, "linux-iio@vger.kernel.org" <linux-iio@vger.kernel.org>, "linux-input@vger.kernel.org" <linux-input@vger.kernel.org> Subject: Re: [PATCH 0/4] Touchscreen performance related fixes Date: Mon, 17 Nov 2014 17:48:43 +0530 [thread overview] Message-ID: <5469E7A3.2000303@ti.com> (raw) In-Reply-To: <5458C87F.80409@linutronix.de> On Tuesday 04 November 2014 06:07 PM, Sebastian Andrzej Siewior wrote: > On 11/04/2014 12:44 PM, Vignesh R wrote: > >> I ran following commands >> $ evtest /dev/input/touchscreen0 & >> (with heavy item on touchscreen) >> and >> $ cat /sys/bus/iio/devices/iio\:device0/scan_elements/in_voltage4_en >> (in a busy loop) >> I tried above experiment on my board but I didn't hit any problem even >> after running for close to 30 minutes. I was unable to reproduce failure > > Just to make sure: You had the touchscreen and iio command running in > parallel and you saw evtest output while there was iio operation? > >> The problem may be in configuring correct charge-delay value. Please run: >> $ ts_test > /dev/null >> and let me know if pen events are being detected properly. > > Well I get the touch events but not while busy loop on iio interface is > running (I get maybe one event every 5 seconds or so). > After all, it is the same HW you have. Were you able to test the latest version (v4) of this patch series? Please let me know if the performance is satisfactory. Regards Vignesh > > Sebastian > -- > To unsubscribe from this list: send the line "unsubscribe linux-omap" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html >
WARNING: multiple messages have this Message-ID (diff)
From: vigneshr@ti.com (Vignesh R) To: linux-arm-kernel@lists.infradead.org Subject: [PATCH 0/4] Touchscreen performance related fixes Date: Mon, 17 Nov 2014 17:48:43 +0530 [thread overview] Message-ID: <5469E7A3.2000303@ti.com> (raw) In-Reply-To: <5458C87F.80409@linutronix.de> On Tuesday 04 November 2014 06:07 PM, Sebastian Andrzej Siewior wrote: > On 11/04/2014 12:44 PM, Vignesh R wrote: > >> I ran following commands >> $ evtest /dev/input/touchscreen0 & >> (with heavy item on touchscreen) >> and >> $ cat /sys/bus/iio/devices/iio\:device0/scan_elements/in_voltage4_en >> (in a busy loop) >> I tried above experiment on my board but I didn't hit any problem even >> after running for close to 30 minutes. I was unable to reproduce failure > > Just to make sure: You had the touchscreen and iio command running in > parallel and you saw evtest output while there was iio operation? > >> The problem may be in configuring correct charge-delay value. Please run: >> $ ts_test > /dev/null >> and let me know if pen events are being detected properly. > > Well I get the touch events but not while busy loop on iio interface is > running (I get maybe one event every 5 seconds or so). > After all, it is the same HW you have. Were you able to test the latest version (v4) of this patch series? Please let me know if the performance is satisfactory. Regards Vignesh > > Sebastian > -- > To unsubscribe from this list: send the line "unsubscribe linux-omap" in > the body of a message to majordomo at vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html >
next prev parent reply other threads:[~2014-11-17 12:19 UTC|newest] Thread overview: 86+ messages / expand[flat|nested] mbox.gz Atom feed top 2014-10-27 11:08 [PATCH 0/4] Touchscreen performance related fixes Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-27 11:08 ` [PATCH 1/4] input: touchscreen: ti_am335x_tsc Interchange touchscreen and ADC steps Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-31 21:03 ` Hartmut Knaack 2014-10-31 21:03 ` Hartmut Knaack 2014-10-31 21:03 ` Hartmut Knaack 2014-11-07 5:48 ` Vignesh R 2014-11-07 5:48 ` Vignesh R 2014-11-07 5:48 ` Vignesh R 2014-11-06 14:19 ` Richard Cochran 2014-11-06 14:19 ` Richard Cochran 2014-11-06 14:19 ` Richard Cochran 2014-11-07 5:34 ` Vignesh R 2014-11-07 5:34 ` Vignesh R 2014-11-07 5:34 ` Vignesh R 2014-11-07 8:00 ` Richard Cochran 2014-11-07 8:00 ` Richard Cochran 2014-11-07 8:00 ` Richard Cochran 2014-11-10 10:46 ` Vignesh R 2014-11-10 10:46 ` Vignesh R 2014-11-10 10:46 ` Vignesh R 2014-11-07 10:17 ` Richard Cochran 2014-11-07 10:17 ` Richard Cochran 2014-11-07 10:17 ` Richard Cochran 2014-10-27 11:08 ` [PATCH 2/4] input: touchscreen: ti_am335x_tsc: Remove udelay in interrupt handler Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-11-03 15:05 ` Lee Jones 2014-11-03 15:05 ` Lee Jones 2014-11-03 15:05 ` Lee Jones 2014-11-07 5:48 ` Vignesh R 2014-11-07 5:48 ` Vignesh R 2014-11-07 5:48 ` Vignesh R 2014-10-27 11:08 ` [PATCH 3/4] arm: boot: dts: am335x-evm: Make charge delay a DT parameter for tsc Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-31 21:09 ` Hartmut Knaack 2014-10-31 21:09 ` Hartmut Knaack 2014-11-07 5:48 ` Vignesh R 2014-11-07 5:48 ` Vignesh R 2014-11-07 5:48 ` Vignesh R 2014-10-27 11:08 ` [PATCH 4/4] input: touchscreen: ti_am335x_tsc: Use charge delay DT parameter Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-27 11:08 ` Vignesh R 2014-10-27 17:34 ` [PATCH 0/4] Touchscreen performance related fixes Sebastian Andrzej Siewior 2014-10-27 17:34 ` Sebastian Andrzej Siewior 2014-10-27 19:02 ` Griffis, Brad 2014-10-27 19:02 ` Griffis, Brad 2014-10-27 19:02 ` Griffis, Brad 2014-10-27 19:02 ` Griffis, Brad 2014-11-03 12:17 ` Sebastian Andrzej Siewior 2014-11-03 12:17 ` Sebastian Andrzej Siewior 2014-11-03 12:17 ` Sebastian Andrzej Siewior 2014-11-04 11:44 ` Vignesh R 2014-11-04 11:44 ` Vignesh R 2014-11-04 11:44 ` Vignesh R 2014-11-04 11:44 ` Vignesh R 2014-11-04 12:37 ` Sebastian Andrzej Siewior 2014-11-04 12:37 ` Sebastian Andrzej Siewior 2014-11-04 12:37 ` Sebastian Andrzej Siewior 2014-11-04 12:37 ` Sebastian Andrzej Siewior 2014-11-05 12:08 ` Vignesh R 2014-11-05 12:08 ` Vignesh R 2014-11-05 12:08 ` Vignesh R 2014-11-05 12:08 ` Vignesh R 2014-11-17 12:18 ` Vignesh R [this message] 2014-11-17 12:18 ` Vignesh R 2014-11-17 12:18 ` Vignesh R 2014-11-03 18:09 ` Richard Cochran 2014-11-03 18:09 ` Richard Cochran 2014-11-03 18:09 ` Richard Cochran 2014-11-06 7:42 ` Vignesh R 2014-11-06 7:42 ` Vignesh R 2014-11-06 7:42 ` Vignesh R 2014-11-12 13:00 ` Johannes Pointner 2014-11-12 13:00 ` Johannes Pointner 2014-11-12 13:00 ` Johannes Pointner 2014-11-13 12:23 ` Vignesh R 2014-11-13 12:23 ` Vignesh R 2014-11-13 12:23 ` Vignesh R 2014-11-17 11:39 ` Vignesh R 2014-11-17 11:39 ` Vignesh R 2014-11-17 11:39 ` Vignesh R
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=5469E7A3.2000303@ti.com \ --to=vigneshr@ti.com \ --cc=balbi@ti.com \ --cc=bcousson@baylibre.com \ --cc=bgriffis@ti.com \ --cc=bigeasy@linutronix.de \ --cc=devicetree@vger.kernel.org \ --cc=dmitry.torokhov@gmail.com \ --cc=galak@codeaurora.org \ --cc=ijc+devicetree@hellion.org.uk \ --cc=jan.kardell@telliq.com \ --cc=jic23@kernel.org \ --cc=knaack.h@gmx.de \ --cc=lars@metafoo.de \ --cc=lee.jones@linaro.org \ --cc=linux-arm-kernel@lists.infradead.org \ --cc=linux-iio@vger.kernel.org \ --cc=linux-input@vger.kernel.org \ --cc=linux-kernel@vger.kernel.org \ --cc=linux-omap@vger.kernel.org \ --cc=linux@arm.linux.org.uk \ --cc=mark.rutland@arm.com \ --cc=paul.gortmaker@windriver.com \ --cc=pawel.moll@arm.com \ --cc=pmeerw@pmeerw.net \ --cc=robh+dt@kernel.org \ --cc=sameo@linux.intel.com \ --cc=tony@atomide.com \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.