All of lore.kernel.org
 help / color / mirror / Atom feed
From: Amit Virdi <amit.virdi@st.com>
To: u-boot@lists.denx.de
Subject: [U-Boot] [PATCH 13/25] SPEAr: spear usbtty configuration does not use ethernet device
Date: Wed, 7 Mar 2012 17:34:02 +0530	[thread overview]
Message-ID: <1331121854-20494-14-git-send-email-amit.virdi@st.com> (raw)
In-Reply-To: <1331121854-20494-1-git-send-email-amit.virdi@st.com>

From: Vipin KUMAR <vipin.kumar@st.com>

Ethernet probing is removed from u-boot compiled as a firmware for spear
flashing utility. This enables faster access to usbtty interface as unused
ethernet i/f is not initialized.

Signed-off-by: Vipin Kumar <vipin.kumar@st.com>
Signed-off-by: Amit Virdi <amit.virdi@st.com>
---
 include/configs/spear-common.h |   10 ++++++++++
 include/configs/spear3xx_evb.h |    3 ++-
 include/configs/spear6xx_evb.h |    1 -
 3 files changed, 12 insertions(+), 2 deletions(-)

diff --git a/include/configs/spear-common.h b/include/configs/spear-common.h
index f4980b0..14e3ec4 100644
--- a/include/configs/spear-common.h
+++ b/include/configs/spear-common.h
@@ -27,6 +27,7 @@
  * Common configurations used for both spear3xx as well as spear6xx
  */
 
+#if !defined(CONFIG_SPEAR_USBTTY)
 /* Ethernet driver configuration */
 #define CONFIG_MII
 #define CONFIG_DESIGNWARE_ETH
@@ -34,6 +35,7 @@
 #define CONFIG_DW0_PHY				1
 #define CONFIG_NET_MULTI
 #define CONFIG_PHY_RESET_DELAY			(10000)		/* in usec */
+#endif
 
 /* USBD driver configuration */
 #define CONFIG_DW_UDC
@@ -109,14 +111,22 @@
 #define CONFIG_CMD_MEMORY
 #define CONFIG_CMD_RUN
 #define CONFIG_CMD_SAVES
+
+#if !defined(CONFIG_SPEAR_USBTTY)
 #define CONFIG_CMD_NET
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_DHCP
+#endif
 
 /* This must be included AFTER the definition of CONFIG_COMMANDS (if any) */
 #include <config_cmd_default.h>
 
+#if defined(CONFIG_SPEAR_USBTTY)
+#undef CONFIG_CMD_NET
+#undef CONFIG_CMD_NFS
+#endif
+
 /*
  * Default Environment Varible definitions
  */
diff --git a/include/configs/spear3xx_evb.h b/include/configs/spear3xx_evb.h
index 263c058..84fad0c 100644
--- a/include/configs/spear3xx_evb.h
+++ b/include/configs/spear3xx_evb.h
@@ -51,6 +51,7 @@
 
 #include <configs/spear-common.h>
 
+#if !defined(CONFIG_SPEAR_USBTTY)
 /* Ethernet driver configuration */
 #define CONFIG_DW_ALTDESCRIPTOR			1
 
@@ -66,6 +67,7 @@
 #define CONFIG_MACB0_PHY			0x01
 
 #endif
+#endif
 
 /* Serial Configuration (PL011) */
 #define CONFIG_SYS_SERIAL0			0xD0000000
@@ -144,7 +146,6 @@
 #endif
 
 /* NAND flash configuration */
-#define CONFIG_SYS_FSMC_NAND_SP
 #define CONFIG_SYS_FSMC_NAND_8BIT
 
 #if defined(CONFIG_SPEAR300)
diff --git a/include/configs/spear6xx_evb.h b/include/configs/spear6xx_evb.h
index a61d9be..d901ba8 100644
--- a/include/configs/spear6xx_evb.h
+++ b/include/configs/spear6xx_evb.h
@@ -49,7 +49,6 @@
 						(void *)CONFIG_SYS_SERIAL1 }
 
 /* NAND flash configuration */
-#define CONFIG_SYS_FSMC_NAND_SP
 #define CONFIG_SYS_FSMC_NAND_8BIT
 #define CONFIG_SYS_NAND_BASE			(0xD2000000)
 
-- 
1.7.2.2

  parent reply	other threads:[~2012-03-07 12:04 UTC|newest]

Thread overview: 79+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2012-03-07 12:03 [U-Boot] [PATCH 00/25] SPEAr: Update platform support for SPEAr3xx/6xx Amit Virdi
2012-03-07 12:03 ` [U-Boot] [PATCH 01/25] SPEAr: Fix ARM relocation support Amit Virdi
2012-03-07 13:11   ` Stefan Roese
2012-03-07 12:03 ` [U-Boot] [PATCH 02/25] SPEAr: Eliminate dependency on Xloader table Amit Virdi
2012-03-07 13:16   ` Stefan Roese
2012-03-07 12:03 ` [U-Boot] [PATCH 03/25] SPEAr: Place ethaddr write and read within CONFIG_CMD_NET Amit Virdi
2012-03-07 13:21   ` Stefan Roese
2012-03-07 13:29     ` Mike Frysinger
2012-03-26 11:23     ` Amit Virdi
2012-03-26 13:15       ` Wolfgang Denk
2012-03-07 12:03 ` [U-Boot] [PATCH 04/25] SPEAr: Configure network support for spear SoCs Amit Virdi
2012-03-07 13:29   ` Stefan Roese
2012-03-26 11:41     ` Amit Virdi
2012-03-26 11:51       ` Stefan Roese
2012-03-07 12:03 ` [U-Boot] [PATCH 05/25] SPEAr: Add macb driver support for spear310 and spear320 Amit Virdi
2012-03-07 12:03 ` [U-Boot] [PATCH 06/25] SPEAr: Add interface information in initialization Amit Virdi
2012-03-07 12:03 ` [U-Boot] [PATCH 07/25] SPEAr: Add basic arch related support for SPEAr SoCs Amit Virdi
2012-03-07 13:49   ` Stefan Roese
2012-03-12 12:30     ` Amit Virdi
2012-03-07 12:03 ` [U-Boot] [PATCH 08/25] SPEAr: Add configuration options for spear3xx and spear6xx boards Amit Virdi
2012-03-07 13:54   ` Stefan Roese
2012-03-26 12:10     ` Amit Virdi
2012-03-26 12:30       ` Stefan Roese
2012-03-27  5:59         ` Amit Virdi
2012-03-07 12:03 ` [U-Boot] [PATCH 09/25] SPEAr: Remove unused flag (CONFIG_SYS_HZ_CLOCK) Amit Virdi
2012-03-07 13:56   ` Stefan Roese
2012-03-07 12:03 ` [U-Boot] [PATCH 10/25] SPEAr: Change the default environment variables Amit Virdi
2012-03-07 14:03   ` Stefan Roese
2012-03-12 12:38     ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 11/25] SPEAr: Initialize SNOR in early_board_init_f Amit Virdi
2012-03-07 14:06   ` Stefan Roese
2012-03-07 12:04 ` [U-Boot] [PATCH 12/25] SPEAr: Enable usb device high speed support Amit Virdi
2012-03-07 14:07   ` Stefan Roese
2012-03-12 12:39     ` Amit Virdi
2012-03-26 12:15       ` Amit Virdi
2012-03-07 12:04 ` Amit Virdi [this message]
2012-03-07 14:14   ` [U-Boot] [PATCH 13/25] SPEAr: spear usbtty configuration does not use ethernet device Stefan Roese
2012-03-12 13:12     ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 14/25] SPEAr: Enable udc and usb-console support only for usbtty configuration Amit Virdi
2012-03-07 14:15   ` Stefan Roese
2012-03-07 12:04 ` [U-Boot] [PATCH 15/25] SPEAr: Enable autoneg for ethernet Amit Virdi
2012-03-07 14:18   ` Stefan Roese
2012-03-27  9:02     ` Amit Virdi
2012-03-27  9:20       ` Stefan Roese
2012-03-27  9:24         ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 16/25] SPEAr: Enable dcache for fast file transfer Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 17/25] SPEAr: Enable CONFIG_SYS_FLASH_PROTECTION Amit Virdi
2012-03-07 14:25   ` Stefan Roese
2012-03-27  6:39     ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 18/25] SPEAr: Correct the definition of CONFIG_SYS_MONITOR_BASE Amit Virdi
2012-03-07 14:31   ` Stefan Roese
2012-03-27  6:38     ` Amit Virdi
2012-03-27  7:05       ` Stefan Roese
2012-03-27  7:42         ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 19/25] SPEAr: Enable CONFIG_SYS_FLASH_EMPTY_INFO macro Amit Virdi
2012-03-07 14:32   ` Stefan Roese
2012-03-27  6:11     ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 20/25] SPEAr: Enable ONFI nand flash detection for spear3xx and 6xx and evb Amit Virdi
2012-03-07 14:34   ` Stefan Roese
2012-03-27  6:09     ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 21/25] SPEAr: explicitly select clk src for UART Amit Virdi
2012-03-07 14:36   ` Stefan Roese
2012-03-07 12:04 ` [U-Boot] [PATCH 22/25] SPEAr: Correct SoC ID offset in misc configuration space Amit Virdi
2012-03-07 14:36   ` Stefan Roese
2012-03-07 12:04 ` [U-Boot] [PATCH 23/25] SPEAr: Use separate config flags for 3xx and 6xx board files Amit Virdi
2012-03-07 14:38   ` Stefan Roese
2012-03-12 13:57     ` Amit Virdi
2012-03-12 14:17       ` Stefan Roese
2012-03-07 12:04 ` [U-Boot] [PATCH 24/25] cleanup/SPEAr: Remove unnecessary parenthesis Amit Virdi
2012-03-07 14:41   ` Stefan Roese
2012-03-07 14:46     ` Stefan Roese
2012-03-12 13:52       ` Amit Virdi
2012-03-07 12:04 ` [U-Boot] [PATCH 25/25] cleanup/SPEAr: Define configuration flags more elegantly Amit Virdi
2012-03-07 14:42   ` Stefan Roese
2012-03-07 13:15 ` [U-Boot] [PATCH 00/25] SPEAr: Update platform support for SPEAr3xx/6xx Stefan Roese
2012-03-07 13:56   ` Amit Virdi
2012-03-09  7:29   ` Vipin Kumar
2012-03-09  7:47     ` Stefan Roese
2012-03-09  8:47       ` Vipin Kumar

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1331121854-20494-14-git-send-email-amit.virdi@st.com \
    --to=amit.virdi@st.com \
    --cc=u-boot@lists.denx.de \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body. 
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.