From: Geert Uytterhoeven <geert@linux-m68k.org> To: Linus Walleij <linus.walleij@linaro.org>, Alexandre Courbot <gnurou@gmail.com>, Arnd Bergmann <arnd@arndb.de> Cc: linux-gpio@vger.kernel.org, linux-kernel@vger.kernel.org, Geert Uytterhoeven <geert@linux-m68k.org>, Jean-Christophe Plagniol-Villard <plagnioj@jcrosoft.com>, Tomi Valkeinen <tomi.valkeinen@ti.com>, linux-fbdev@vger.kernel.org Subject: [PATCH 24/27] fbdev: Allow compile test of GPIO consumers if !GPIOLIB Date: Tue, 5 May 2015 18:32:40 +0200 [thread overview] Message-ID: <1430843563-18615-24-git-send-email-geert@linux-m68k.org> (raw) In-Reply-To: <1430843563-18615-1-git-send-email-geert@linux-m68k.org> The GPIO subsystem provides dummy GPIO consumer functions if GPIOLIB is not enabled. Hence drivers that depend on GPIOLIB, but use GPIO consumer functionality only, can still be compiled if GPIOLIB is not enabled. Relax the dependency on GPIOLIB if COMPILE_TEST is enabled, where appropriate. Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org> Cc: Jean-Christophe Plagniol-Villard <plagnioj@jcrosoft.com> Cc: Tomi Valkeinen <tomi.valkeinen@ti.com> Cc: linux-fbdev@vger.kernel.org --- drivers/video/fbdev/Kconfig | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/video/fbdev/Kconfig b/drivers/video/fbdev/Kconfig index 1094623030879dcd..bc94c782370f2156 100644 --- a/drivers/video/fbdev/Kconfig +++ b/drivers/video/fbdev/Kconfig @@ -2471,7 +2471,7 @@ config FB_SSD1307 tristate "Solomon SSD1307 framebuffer support" depends on FB && I2C depends on OF - depends on GPIOLIB + depends on GPIOLIB || COMPILE_TEST select FB_SYS_FOPS select FB_SYS_FILLRECT select FB_SYS_COPYAREA -- 1.9.1
WARNING: multiple messages have this Message-ID (diff)
From: Geert Uytterhoeven <geert@linux-m68k.org> To: Linus Walleij <linus.walleij@linaro.org>, Alexandre Courbot <gnurou@gmail.com>, Arnd Bergmann <arnd@arndb.de> Cc: linux-gpio@vger.kernel.org, linux-kernel@vger.kernel.org, Geert Uytterhoeven <geert@linux-m68k.org>, Jean-Christophe Plagniol-Villard <plagnioj@jcrosoft.com>, Tomi Valkeinen <tomi.valkeinen@ti.com>, linux-fbdev@vger.kernel.org Subject: [PATCH 24/27] fbdev: Allow compile test of GPIO consumers if !GPIOLIB Date: Tue, 05 May 2015 16:32:40 +0000 [thread overview] Message-ID: <1430843563-18615-24-git-send-email-geert@linux-m68k.org> (raw) In-Reply-To: <1430843563-18615-1-git-send-email-geert@linux-m68k.org> The GPIO subsystem provides dummy GPIO consumer functions if GPIOLIB is not enabled. Hence drivers that depend on GPIOLIB, but use GPIO consumer functionality only, can still be compiled if GPIOLIB is not enabled. Relax the dependency on GPIOLIB if COMPILE_TEST is enabled, where appropriate. Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org> Cc: Jean-Christophe Plagniol-Villard <plagnioj@jcrosoft.com> Cc: Tomi Valkeinen <tomi.valkeinen@ti.com> Cc: linux-fbdev@vger.kernel.org --- drivers/video/fbdev/Kconfig | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/video/fbdev/Kconfig b/drivers/video/fbdev/Kconfig index 1094623030879dcd..bc94c782370f2156 100644 --- a/drivers/video/fbdev/Kconfig +++ b/drivers/video/fbdev/Kconfig @@ -2471,7 +2471,7 @@ config FB_SSD1307 tristate "Solomon SSD1307 framebuffer support" depends on FB && I2C depends on OF - depends on GPIOLIB + depends on GPIOLIB || COMPILE_TEST select FB_SYS_FOPS select FB_SYS_FILLRECT select FB_SYS_COPYAREA -- 1.9.1
next prev parent reply other threads:[~2015-05-05 16:32 UTC|newest] Thread overview: 62+ messages / expand[flat|nested] mbox.gz Atom feed top 2015-05-05 14:33 [PATCH 00/27] gpio: Allow compile test of GPIO consumers if !GPIOLIB Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 01/27] drm/bridge: ptn3460: #include <linux/gpio/consumer.h>, depend on GPIOLIB Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 02/27] drm/bridge: ps8622: " Geert Uytterhoeven 2015-06-05 11:21 ` Thierry Reding 2015-05-05 16:32 ` [PATCH 03/27] tpm: Allow compile test of GPIO consumers if !GPIOLIB Geert Uytterhoeven 2015-05-05 20:57 ` Peter Hüwe 2015-05-05 16:32 ` [PATCH 04/27] extcon: " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-06 5:38 ` Chanwoo Choi 2015-05-05 16:32 ` [PATCH 05/27] hwmon: " Geert Uytterhoeven 2015-05-05 16:32 ` [lm-sensors] " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-05 19:31 ` Guenter Roeck 2015-05-05 19:31 ` [lm-sensors] " Guenter Roeck 2015-05-05 16:32 ` [PATCH 06/27] i2c: " Geert Uytterhoeven 2015-05-12 13:23 ` wsa 2015-05-05 16:32 ` [PATCH 07/27] iio: " Geert Uytterhoeven 2015-05-07 10:37 ` Jonathan Cameron 2015-05-05 16:32 ` [PATCH 08/27] input: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 09/27] leds: " Geert Uytterhoeven 2015-05-06 7:58 ` Jacek Anaszewski 2015-05-06 8:31 ` Geert Uytterhoeven 2015-05-07 12:14 ` Jacek Anaszewski 2015-05-05 16:32 ` [PATCH 10/27] [media] wl128x: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 11/27] mfd: " Geert Uytterhoeven 2015-05-07 7:37 ` Lee Jones 2015-05-05 16:32 ` [PATCH 12/27] misc: ti-st: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 13/27] mtd: " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-20 22:51 ` Brian Norris 2015-05-20 22:51 ` Brian Norris 2015-05-05 16:32 ` [PATCH 14/27] net: phy: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 15/27] power: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 16/27] regulator: " Geert Uytterhoeven 2015-05-06 15:20 ` Mark Brown [not found] ` <1430843563-18615-1-git-send-email-geert-Td1EMuHUCqxL1ZNQvxDV9g@public.gmane.org> 2015-05-05 16:32 ` [PATCH 17/27] spi: " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-06 15:21 ` Mark Brown 2015-05-05 16:32 ` [PATCH 18/27] staging: android: " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 19/27] staging: fbtft: " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 20/27] Staging: iio: " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-07 10:38 ` Jonathan Cameron 2015-05-05 16:32 ` [PATCH 21/27] serial: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 22/27] usb: phy: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 23/27] backlight: " Geert Uytterhoeven 2015-05-05 16:32 ` Geert Uytterhoeven 2015-05-07 7:37 ` Lee Jones 2015-05-07 7:37 ` Lee Jones 2015-05-05 16:32 ` Geert Uytterhoeven [this message] 2015-05-05 16:32 ` [PATCH 24/27] fbdev: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 25/27] w1: " Geert Uytterhoeven 2015-05-05 16:32 ` [PATCH 26/27] watchdog: " Geert Uytterhoeven 2015-05-05 19:31 ` Guenter Roeck 2015-05-05 16:32 ` [PATCH 27/27] net: rfkill: " Geert Uytterhoeven 2015-06-05 11:20 ` [PATCH 01/27] drm/bridge: ptn3460: #include <linux/gpio/consumer.h>, depend on GPIOLIB Thierry Reding 2015-06-05 11:42 ` Geert Uytterhoeven 2015-06-05 11:42 ` Geert Uytterhoeven 2015-05-12 10:20 ` [PATCH 00/27] gpio: Allow compile test of GPIO consumers if !GPIOLIB Linus Walleij
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=1430843563-18615-24-git-send-email-geert@linux-m68k.org \ --to=geert@linux-m68k.org \ --cc=arnd@arndb.de \ --cc=gnurou@gmail.com \ --cc=linus.walleij@linaro.org \ --cc=linux-fbdev@vger.kernel.org \ --cc=linux-gpio@vger.kernel.org \ --cc=linux-kernel@vger.kernel.org \ --cc=plagnioj@jcrosoft.com \ --cc=tomi.valkeinen@ti.com \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.