Re: [PATCH v2 2/2] net: flexcan: add transceiver switch gpios support

[Shawn Guo <shawn.guo@linaro.org>]

On Thu, Jun 28, 2012 at 07:33:28PM +0800, Dong Aisheng wrote:
> > +		phy_stby_gpio = of_get_named_gpio_flags(pdev->dev.of_node,
> > +							"phy-standby-gpios",
> > +							0, &flags);
> > +		if (gpio_is_valid(phy_stby_gpio)) {
> > +			if (flags == OF_GPIO_ACTIVE_LOW)
> > +				phy_stby_high = false;
> > +			err = devm_gpio_request_one(&pdev->dev, phy_stby_gpio,
> > +						    GPIOF_DIR_OUT,
> > +						    "phy-standby");
> > +			if (err) {
> > +				dev_err(&pdev->dev,
> > +					"failed to request gpio %d: %d\n",
> > +					phy_stby_gpio, err);
> > +				goto failed_gpio;
> I checked mx28 evk, it seems the phy only has a STB gpio and shared by both CAN0&CAN1.
> I wonder the CAN1 probe may fail here.
> 
It can be managed by dts.  Here is what I have in imx28-evk.dts, where
only can0 has phy-enable-gpios property.


	can0: can@80032000 {
		pinctrl-names = "default";
		pinctrl-0 = <&can0_pins_a>;
		phy-enable-gpios = <&gpio2 13 0>;
		status = "okay";
	};

	can1: can@80034000 {
		pinctrl-names = "default";
		pinctrl-0 = <&can1_pins_a>;
		status = "okay";
	};


-- 
Regards,
Shawn