[PATCH v3 3/4] dt-bindings: phy: qcom,qmp: Describe phy@ subnode properly

[Bhupesh Sharma <bhupesh.sharma@linaro.org>]

Currently the qcom,qmp-phy dt-binding doesn't describe
the 'reg' and '#phy-cells' properties for the phy@ subnode.

Fix the same.

Cc: Bjorn Andersson <bjorn.andersson@linaro.org>
Cc: Rob Herring <robh@kernel.org>
Signed-off-by: Bhupesh Sharma <bhupesh.sharma@linaro.org>
---
 .../devicetree/bindings/phy/qcom,qmp-phy.yaml       | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/Documentation/devicetree/bindings/phy/qcom,qmp-phy.yaml b/Documentation/devicetree/bindings/phy/qcom,qmp-phy.yaml
index 411c79dbfa15..c553c8ad0d1a 100644
--- a/Documentation/devicetree/bindings/phy/qcom,qmp-phy.yaml
+++ b/Documentation/devicetree/bindings/phy/qcom,qmp-phy.yaml
@@ -118,6 +118,19 @@ patternProperties:
       Each device node of QMP phy is required to have as many child nodes as
       the number of lanes the PHY has.
     properties:
+      reg:
+        minItems: 1
+        maxItems: 6
+        items:
+          description: |
+            List of offset and length pairs of register sets for PHY blocks.
+            common block control registers, such as - SW_RESET, START_CTRL.
+            pcs registers, such as - PCS_STATUS, POWER_DOWN_CONTROL,
+            pcs misc registers, such as - PCS_MISC_TYPEC_CTRL.
+
+      "#phy-cells":
+        const: 0
+
       "#clock-cells":
         enum: [ 0, 1, 2 ]
 
-- 
2.35.1