From: Stefan Agner <stefan@agner.ch> To: Shawn Guo <shawnguo@kernel.org> Cc: mturquette@baylibre.com, sboyd@codeaurora.org, kernel@pengutronix.de, sergeimir@emcraft.com, tglx@linutronix.de, jason@lakedaemon.net, marc.zyngier@arm.com, robh+dt@kernel.org, pawel.moll@arm.com, mark.rutland@arm.com, ijc+devicetree@hellion.org.uk, galak@codeaurora.org, devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org, linux-clk@vger.kernel.org Subject: Re: [PATCH 06/18] ARM: imx: clk-gate2: allow custom gate configuration Date: Thu, 31 Mar 2016 10:59:54 -0700 [thread overview] Message-ID: <f21855561b6cbf2d2a57508ed9470ed0@agner.ch> (raw) In-Reply-To: <20160331113728.GA18833@tiger> On 2016-03-31 04:37, Shawn Guo wrote: > On Wed, Mar 09, 2016 at 06:16:47PM -0800, Stefan Agner wrote: >> The 2-bit gates found i.MX and Vybrid SoC support different clock >> configuration: >> >> 0b00: clk disabled >> 0b01: clk enabled in RUN mode but disabled in WAIT and STOP mode >> 0b10: clk enabled in RUN, WAIT and STOP mode (only Vybrid) >> 0b11: clk enabled in RUN and WAIT mode >> >> For some clocks, we might want to configure different behaviour, >> e.g. a memory clock should be on even in STOP mode. Add a new >> function imx_clk_gate2_cgr which allow to configure specific >> gate values through the cgr_val parameter. >> >> Signed-off-by: Stefan Agner <stefan@agner.ch> > > It's not appropriate to use 'ARM:' as subject prefix any more, since > clock drivers had been moved to drivers/clk. Agreed. Evidence on how long I dragged those patches in my own tree :-/ > > I applied patch 6 ~ 9 with updating the subject prefix as below. > > clk: imx: vf610: add suspend/resume support > clk: imx: vf610: add WKPU unit > clk: imx: vf610: leave DDR clock on > clk: imx: clk-gate2: allow custom gate configuration Thanks! -- Stefan
WARNING: multiple messages have this Message-ID (diff)
From: stefan@agner.ch (Stefan Agner) To: linux-arm-kernel@lists.infradead.org Subject: [PATCH 06/18] ARM: imx: clk-gate2: allow custom gate configuration Date: Thu, 31 Mar 2016 10:59:54 -0700 [thread overview] Message-ID: <f21855561b6cbf2d2a57508ed9470ed0@agner.ch> (raw) In-Reply-To: <20160331113728.GA18833@tiger> On 2016-03-31 04:37, Shawn Guo wrote: > On Wed, Mar 09, 2016 at 06:16:47PM -0800, Stefan Agner wrote: >> The 2-bit gates found i.MX and Vybrid SoC support different clock >> configuration: >> >> 0b00: clk disabled >> 0b01: clk enabled in RUN mode but disabled in WAIT and STOP mode >> 0b10: clk enabled in RUN, WAIT and STOP mode (only Vybrid) >> 0b11: clk enabled in RUN and WAIT mode >> >> For some clocks, we might want to configure different behaviour, >> e.g. a memory clock should be on even in STOP mode. Add a new >> function imx_clk_gate2_cgr which allow to configure specific >> gate values through the cgr_val parameter. >> >> Signed-off-by: Stefan Agner <stefan@agner.ch> > > It's not appropriate to use 'ARM:' as subject prefix any more, since > clock drivers had been moved to drivers/clk. Agreed. Evidence on how long I dragged those patches in my own tree :-/ > > I applied patch 6 ~ 9 with updating the subject prefix as below. > > clk: imx: vf610: add suspend/resume support > clk: imx: vf610: add WKPU unit > clk: imx: vf610: leave DDR clock on > clk: imx: clk-gate2: allow custom gate configuration Thanks! -- Stefan
next prev parent reply other threads:[~2016-03-31 18:03 UTC|newest] Thread overview: 96+ messages / expand[flat|nested] mbox.gz Atom feed top 2016-03-10 2:16 [PATCH 00/18] ARM: vf610: Suspend/resume with self-refresh mode Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 01/18] irqchip: vf610-gpc: add Vybrid GPC IRQ controller Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-11 3:41 ` Marc Zyngier 2016-03-11 3:41 ` Marc Zyngier 2016-03-11 3:41 ` Marc Zyngier 2016-03-11 18:11 ` Stefan Agner 2016-03-11 18:11 ` Stefan Agner 2016-03-11 18:11 ` Stefan Agner 2016-03-12 0:21 ` Marc Zyngier 2016-03-12 0:21 ` Marc Zyngier 2016-03-31 8:07 ` Shawn Guo 2016-03-31 8:07 ` Shawn Guo 2016-03-10 2:16 ` [PATCH 02/18] ARM: dts: vf610: add GPC as new interrupt parent Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-31 8:21 ` Shawn Guo 2016-03-31 8:21 ` Shawn Guo 2016-03-31 17:53 ` Stefan Agner 2016-03-31 17:53 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 03/18] ARM: dts: vf610-colibri: GPIO wakeup key Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-31 8:19 ` Shawn Guo 2016-03-31 8:19 ` Shawn Guo 2016-03-31 17:55 ` Stefan Agner 2016-03-31 17:55 ` Stefan Agner 2016-03-31 17:55 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 04/18] ARM: dts: vf610: add on-chip SRAM Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-31 8:33 ` Shawn Guo 2016-03-31 8:33 ` Shawn Guo 2016-03-31 17:57 ` Stefan Agner 2016-03-31 17:57 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 05/18] ARM: dts: vf610: add modules required for PM Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-31 8:34 ` Shawn Guo 2016-03-31 8:34 ` Shawn Guo 2016-03-31 8:34 ` Shawn Guo 2016-03-10 2:16 ` [PATCH 06/18] ARM: imx: clk-gate2: allow custom gate configuration Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-31 11:37 ` Shawn Guo 2016-03-31 11:37 ` Shawn Guo 2016-03-31 17:59 ` Stefan Agner [this message] 2016-03-31 17:59 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 07/18] ARM: imx: clk-vf610: leave DDR clock on Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 08/18] ARM: clk: add WKPU unit Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-16 1:13 ` Stephen Boyd 2016-03-16 1:13 ` Stephen Boyd 2016-03-10 2:16 ` [PATCH 09/18] ARM: vf610: clk: add suspend/resume support Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-31 11:39 ` Shawn Guo 2016-03-31 11:39 ` Shawn Guo 2016-03-10 2:16 ` [PATCH 10/18] tty: serial: fsl_lpuart: support suspend/resume Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-31 11:41 ` Shawn Guo 2016-03-31 11:41 ` Shawn Guo 2016-03-10 2:16 ` [PATCH 11/18] pinctrl: pinctrl-imx: implement suspend/resume Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 12/18] gpio: vf610: add system PM suspend/resume Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 13/18] ARM: dts: vf610: add WKPU connection to GPIO Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 14/18] gpio: vf610: add support for WKPU unit Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-17 20:00 ` Rob Herring 2016-03-17 20:00 ` Rob Herring 2016-03-17 22:12 ` Stefan Agner 2016-03-17 22:12 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 15/18] ARM: vf610: PM: initial suspend/resume support Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 21:19 ` kbuild test robot 2016-03-10 21:19 ` kbuild test robot 2016-03-10 21:19 ` kbuild test robot 2016-04-01 2:25 ` Shawn Guo 2016-04-01 2:25 ` Shawn Guo 2016-04-01 6:40 ` Stefan Agner 2016-04-01 6:40 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 16/18] ARM: vf610: PM: enable Suspend-to-RAM only if hardware fixes are in place Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` [PATCH 17/18] Documentation: dt: add Vybrid DDR memory controller bindings Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-10 2:16 ` Stefan Agner 2016-03-18 16:10 ` Rob Herring 2016-03-18 16:10 ` Rob Herring 2016-03-10 2:16 ` [PATCH 18/18] ARM: vf610: PM: enable SNVS access Stefan Agner 2016-03-10 2:16 ` Stefan Agner
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=f21855561b6cbf2d2a57508ed9470ed0@agner.ch \ --to=stefan@agner.ch \ --cc=devicetree@vger.kernel.org \ --cc=galak@codeaurora.org \ --cc=ijc+devicetree@hellion.org.uk \ --cc=jason@lakedaemon.net \ --cc=kernel@pengutronix.de \ --cc=linux-arm-kernel@lists.infradead.org \ --cc=linux-clk@vger.kernel.org \ --cc=linux-kernel@vger.kernel.org \ --cc=marc.zyngier@arm.com \ --cc=mark.rutland@arm.com \ --cc=mturquette@baylibre.com \ --cc=pawel.moll@arm.com \ --cc=robh+dt@kernel.org \ --cc=sboyd@codeaurora.org \ --cc=sergeimir@emcraft.com \ --cc=shawnguo@kernel.org \ --cc=tglx@linutronix.de \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.