Linux-ARM-Kernel Archive on lore.kernel.org
 help / color / Atom feed
From: Maxime Ripard <maxime.ripard@bootlin.com>
To: Jagan Teki <jagan@amarulasolutions.com>
Cc: Mark Rutland <mark.rutland@arm.com>,
	devicetree@vger.kernel.org, David Airlie <airlied@linux.ie>,
	Michael Turquette <mturquette@baylibre.com>,
	linux-sunxi@googlegroups.com, linux-kernel@vger.kernel.org,
	dri-devel@lists.freedesktop.org, Chen-Yu Tsai <wens@csie.org>,
	Rob Herring <robh+dt@kernel.org>, Daniel Vetter <daniel@ffwll.ch>,
	Michael Trimarchi <michael@amarulasolutions.com>,
	linux-amarula@amarulasolutions.com, linux-clk@vger.kernel.org,
	linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH v6 11/22] clk: sunxi-ng: a64: Add minimum rate for PLL_MIPI
Date: Fri, 25 Jan 2019 22:24:33 +0100
Message-ID: <20190125212433.ni2jg3wvpyjazlxf@flea> (raw)
In-Reply-To: <20190124195900.22620-12-jagan@amarulasolutions.com>

On Fri, Jan 25, 2019 at 01:28:49AM +0530, Jagan Teki wrote:
> Minimum PLL used for MIPI is 500MHz, as per manual, but
> lowering the min rate by 300MHz can result proper working
> nkms divider with the help of desired dclock rate from
> panel driver.
> 
> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
> Acked-by: Stephen Boyd <sboyd@kernel.org>

Going 200MHz below the minimum doesn't seem really reasonable. What
is the issue that you are trying to fix here?

It looks like it's picking bad dividers, but if that's the case, this
isn't the proper fix.

Maxime

-- 
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  reply index

Thread overview: 66+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-01-24 19:58 [PATCH v6 00/22] drm/sun4i: Allwinner A64 MIPI-DSI support Jagan Teki
2019-01-24 19:58 ` [PATCH v6 01/22] drm/sun4i: sun6i_mipi_dsi: Compute burst mode loop N1 instruction delay Jagan Teki
2019-01-24 19:58 ` [PATCH v6 02/22] drm/sun4i: sun6i_mipi_dsi: Support instruction loop selection Jagan Teki
2019-01-24 19:58 ` [PATCH v6 03/22] drm/sun4i: sun6i_mipi_dsi: Setup burst mode timings Jagan Teki
2019-01-24 19:58 ` [PATCH v6 04/22] drm/sun4i: sun6i_mipi_dsi: Simplify drq to support all modes Jagan Teki
2019-01-24 19:58 ` [PATCH v6 05/22] drm/sun4i: tcon: Export get tcon0 routine Jagan Teki
2019-01-24 19:58 ` [PATCH v6 06/22] drm/sun4i: sun6i_mipi_dsi: Probe tcon0 during dsi_bind Jagan Teki
2019-01-24 19:58 ` [PATCH v6 07/22] drm/sun4i: sun6i_mipi_dsi: Setup burst mode Jagan Teki
2019-01-24 19:58 ` [PATCH v6 08/22] drm/sun4i: sun6i_mipi_dsi: Enable 2byte trail for 4-lane " Jagan Teki
2019-01-24 19:58 ` [PATCH v6 09/22] drm/sun4i: sun6i_mipi_dsi: Enable burst mode HBP, HSA_HSE Jagan Teki
2019-01-24 19:58 ` [PATCH v6 10/22] clk: sunxi-ng: Add check for minimal rate to NKM PLLs Jagan Teki
2019-01-24 19:58 ` [PATCH v6 11/22] clk: sunxi-ng: a64: Add minimum rate for PLL_MIPI Jagan Teki
2019-01-25 21:24   ` Maxime Ripard [this message]
2019-01-28  9:36     ` Jagan Teki
2019-01-29 15:13       ` Maxime Ripard
2019-01-29 17:31         ` Jagan Teki
2019-02-01 14:31           ` Maxime Ripard
2019-02-01 16:33             ` Jagan Teki
2019-02-11 14:07             ` Jagan Teki
2019-02-12  9:30               ` Maxime Ripard
2019-02-12  9:38                 ` Jagan Teki
2019-05-24 10:07             ` Jagan Teki
2019-06-05  6:49               ` Maxime Ripard
2019-06-05  7:33                 ` Jagan Teki
2019-06-14 14:24                   ` Maxime Ripard
2019-06-20 18:27                     ` Jagan Teki
2019-06-25 14:49                       ` Maxime Ripard
2019-06-25 15:30                         ` Jagan Teki
2019-07-03 11:49                           ` Maxime Ripard
2019-07-05 17:52                             ` Michael Nazzareno Trimarchi
2019-07-11 10:01                               ` Maxime Ripard
2019-07-11 17:43                                 ` Michael Nazzareno Trimarchi
2019-07-11 19:34                                   ` Michael Nazzareno Trimarchi
2019-07-20  6:58                                   ` Maxime Ripard
2019-07-20  7:16                                     ` Jagan Teki
2019-07-20  7:34                                       ` Jagan Teki
2019-07-20  9:32                                       ` Maxime Ripard
2019-07-20  9:42                                         ` Michael Nazzareno Trimarchi
2019-07-22 10:21                                         ` Jagan Teki
2019-07-22 10:25                                           ` Michael Nazzareno Trimarchi
2019-07-22 10:38                                             ` Jagan Teki
2019-07-24  9:05                                           ` Maxime Ripard
2019-07-29  6:59                                             ` Michael Nazzareno Trimarchi
2019-08-02  8:38                                               ` Michael Nazzareno Trimarchi
2019-08-13  6:05                                               ` Maxime Ripard
2019-08-15 12:25                                                 ` Michael Nazzareno Trimarchi
2019-08-28 13:03                                                   ` Maxime Ripard
2019-08-28 13:09                                                     ` Michael Nazzareno Trimarchi
2019-01-24 19:58 ` [PATCH v6 12/22] dt-bindings: sun6i-dsi: Add VCC-DSI supply property Jagan Teki
2019-01-25 15:47   ` Maxime Ripard
2019-01-24 19:58 ` [PATCH v6 13/22] drm/sun4i: sun6i_mipi_dsi: Add support for VCC-DSI voltage regulator Jagan Teki
2019-01-24 19:58 ` [PATCH v6 14/22] dt-bindings: sun6i-dsi: Add A64 DSI compatible (w/ A31 fallback) Jagan Teki
2019-01-25 15:52   ` Maxime Ripard
2019-01-26 16:09     ` [linux-sunxi] " Jagan Teki
2019-01-29 14:54       ` Maxime Ripard
2019-01-24 19:58 ` [PATCH v6 15/22] dt-bindings: sun6i-dsi: Add A64 DPHY " Jagan Teki
2019-01-25 15:52   ` Maxime Ripard
2019-01-24 19:58 ` [PATCH v6 16/22] arm64: dts: allwinner: a64: Add DSI pipeline Jagan Teki
2019-01-25 18:51   ` Maxime Ripard
2019-01-24 19:58 ` [DO NOT MERGE] [PATCH v6 17/22] arm64: allwinner: a64: pine64-lts: Enable Feiyang FY07024DI26A30-D DSI panel Jagan Teki
2019-01-24 19:58 ` [PATCH v6 18/22] drm/sun4i: sun6i_mipi_dsi: Add DSI Generic short write 2 param transfer Jagan Teki
2019-01-24 19:58 ` [DO NOT MERGE] [PATCH v6 19/22] arm64: dts: allwinner: bananapi-m64: Bananapi S070WV20-CT16 DSI panel Jagan Teki
2019-01-24 19:58 ` [PATCH v6 20/22] drm/sun4i: sun6i_mipi_dsi: Fix DSI hbp timing value Jagan Teki
2019-01-24 19:58 ` [PATCH v6 21/22] drm/sun4i: sun6i_mipi_dsi: Fix DSI hfp " Jagan Teki
2019-01-24 19:59 ` [PATCH v6 22/22] arm64: dts: allwinner: a64-amarula-relic: Add Techstar TS8550B MIPI-DSI panel Jagan Teki
2019-01-24 23:12 ` [PATCH v6 00/22] drm/sun4i: Allwinner A64 MIPI-DSI support Merlijn Wajer

Reply instructions:

You may reply publically to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20190125212433.ni2jg3wvpyjazlxf@flea \
    --to=maxime.ripard@bootlin.com \
    --cc=airlied@linux.ie \
    --cc=daniel@ffwll.ch \
    --cc=devicetree@vger.kernel.org \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=jagan@amarulasolutions.com \
    --cc=linux-amarula@amarulasolutions.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-sunxi@googlegroups.com \
    --cc=mark.rutland@arm.com \
    --cc=michael@amarulasolutions.com \
    --cc=mturquette@baylibre.com \
    --cc=robh+dt@kernel.org \
    --cc=wens@csie.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-ARM-Kernel Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/0 linux-arm-kernel/git/0.git
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/1 linux-arm-kernel/git/1.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-arm-kernel linux-arm-kernel/ https://lore.kernel.org/linux-arm-kernel \
		linux-arm-kernel@lists.infradead.org infradead-linux-arm-kernel@archiver.kernel.org
	public-inbox-index linux-arm-kernel


Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.infradead.lists.linux-arm-kernel


AGPL code for this site: git clone https://public-inbox.org/ public-inbox