From: Miquel Raynal <miquel.raynal@bootlin.com>
To: Gregory Clement <gregory.clement@bootlin.com>,
Jason Cooper <jason@lakedaemon.net>, Andrew Lunn <andrew@lunn.ch>,
Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>,
Thomas Petazzoni <thomas.petazzoni@bootlin.com>,
Bjorn Helgaas <bhelgaas@google.com>
Cc: <devicetree@vger.kernel.org>, Rob Herring <robh+dt@kernel.org>,
Mark Rutland <mark.rutland@arm.com>,
Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>,
linux-pci@vger.kernel.org, <linux-kernel@vger.kernel.org>,
<linux-arm-kernel@lists.infradead.org>,
Antoine Tenart <antoine.tenart@bootlin.com>,
Maxime Chevallier <maxime.chevallier@bootlin.com>,
Nadav Haklai <nadavh@marvell.com>,
Miquel Raynal <miquel.raynal@bootlin.com>
Subject: [PATCH v3 07/15] PCI: aardvark: Add suspend to RAM support
Date: Tue, 8 Jan 2019 17:24:32 +0100 [thread overview]
Message-ID: <20190108162441.5278-8-miquel.raynal@bootlin.com> (raw)
In-Reply-To: <20190108162441.5278-1-miquel.raynal@bootlin.com>
Add suspend and resume callbacks. The priority of these are
"_noirq()", to workaround early access to the registers done by the
PCI core through the ->read()/->write() callbacks at resume time.
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
drivers/pci/controller/pci-aardvark.c | 45 ++++++++++++++++++++++++++-
1 file changed, 44 insertions(+), 1 deletion(-)
diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
index 3fb14e37eb59..999bbe27761a 100644
--- a/drivers/pci/controller/pci-aardvark.c
+++ b/drivers/pci/controller/pci-aardvark.c
@@ -1028,7 +1028,7 @@ static int advk_pcie_setup_clk(struct advk_pcie *pcie)
return ret;
}
-static void __maybe_unused advk_pcie_disable_phy(struct advk_pcie *pcie)
+static void advk_pcie_disable_phy(struct advk_pcie *pcie)
{
phy_power_off(pcie->phy);
phy_exit(pcie->phy);
@@ -1119,6 +1119,47 @@ static int advk_pcie_setup_reset_gpio(struct advk_pcie *pcie)
return 0;
}
+static int __maybe_unused advk_pcie_suspend(struct device *dev)
+{
+ struct advk_pcie *pcie = dev_get_drvdata(dev);
+
+ advk_pcie_disable_phy(pcie);
+
+ clk_disable_unprepare(pcie->clk);
+
+ return 0;
+}
+
+static int __maybe_unused advk_pcie_resume(struct device *dev)
+{
+ struct advk_pcie *pcie = dev_get_drvdata(dev);
+ int ret;
+
+ ret = clk_prepare_enable(pcie->clk);
+ if (ret)
+ return ret;
+
+ ret = advk_pcie_enable_phy(pcie);
+ if (ret)
+ return ret;
+
+ advk_pcie_setup_hw(pcie);
+
+ advk_sw_pci_bridge_init(pcie);
+
+ return 0;
+}
+
+/*
+ * The PCI core will try to reconfigure the bus quite early in the resume path.
+ * We must use the _noirq() alternatives to ensure the controller is ready when
+ * the core uses the ->read()/->write() callbacks.
+ */
+static const struct dev_pm_ops advk_pcie_dev_pm_ops = {
+ SET_NOIRQ_SYSTEM_SLEEP_PM_OPS(advk_pcie_suspend,
+ advk_pcie_resume)
+};
+
static int advk_pcie_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
@@ -1133,6 +1174,7 @@ static int advk_pcie_probe(struct platform_device *pdev)
pcie = pci_host_bridge_priv(bridge);
pcie->pdev = pdev;
+ platform_set_drvdata(pdev, pcie);
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
pcie->base = devm_ioremap_resource(dev, res);
@@ -1210,6 +1252,7 @@ static struct platform_driver advk_pcie_driver = {
.driver = {
.name = "advk-pcie",
.of_match_table = advk_pcie_of_match_table,
+ .pm = &advk_pcie_dev_pm_ops,
/* Driver unloading/unbinding currently not supported */
.suppress_bind_attrs = true,
},
--
2.19.1
next prev parent reply other threads:[~2019-01-08 16:25 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-01-08 16:24 [PATCH v3 00/15] Bring suspend to RAM support to PCIe Aardvark driver Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 01/15] PCI: aardvark: Enlarge PIO timeout Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 02/15] PCI: aardvark: Configure more registers in the configuration helper Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 03/15] PCI: aardvark: Add clock support Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 04/15] PCI: aardvark: Add PHY support Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 05/15] PCI: aardvark: Add PCIe warm reset support Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 06/15] PCI: aardvark: Add external reset GPIO support Miquel Raynal
2019-01-08 16:24 ` Miquel Raynal [this message]
2019-01-08 16:24 ` [PATCH v3 08/15] dt-bindings: PCI: aardvark: Describe the clocks property Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 09/15] dt-bindings: PCI: aardvark: Describe the PHY property Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 10/15] dt-bindings: PCI: aardvark: Describe the PCIe endpoint card reset pins Miquel Raynal
2019-01-15 20:13 ` Rob Herring
2019-01-08 16:24 ` [PATCH v3 11/15] dt-bindings: PCI: aardvark: Describe the reset-gpios property Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 12/15] ARM64: dts: marvell: armada-37xx: declare PCIe clock Miquel Raynal
2019-01-08 16:24 ` [PATCH v3 13/15] ARM64: dts: marvell: armada-3720-espressobin: declare PCIe PHY Miquel Raynal
2019-02-06 14:17 ` Gregory CLEMENT
2019-01-08 16:24 ` [PATCH v3 14/15] ARM64: dts: marvell: armada-37xx: declare PCIe reset pin Miquel Raynal
2019-02-06 11:11 ` Gregory CLEMENT
2019-01-08 16:24 ` [PATCH v3 15/15] ARM64: dts: marvell: armada-3720-espressobin: declare PCIe warm " Miquel Raynal
2019-02-06 11:12 ` Gregory CLEMENT
2019-01-18 16:51 ` [PATCH v3 00/15] Bring suspend to RAM support to PCIe Aardvark driver Gregory CLEMENT
2019-01-20 15:16 ` Miquel Raynal
2019-01-23 17:05 ` Lorenzo Pieralisi
2019-01-25 10:05 ` Miquel Raynal
2019-01-25 12:40 ` Lorenzo Pieralisi
2019-01-25 12:57 ` Miquel Raynal
2019-01-25 17:38 ` Lorenzo Pieralisi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190108162441.5278-8-miquel.raynal@bootlin.com \
--to=miquel.raynal@bootlin.com \
--cc=andrew@lunn.ch \
--cc=antoine.tenart@bootlin.com \
--cc=bhelgaas@google.com \
--cc=devicetree@vger.kernel.org \
--cc=gregory.clement@bootlin.com \
--cc=jason@lakedaemon.net \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pci@vger.kernel.org \
--cc=lorenzo.pieralisi@arm.com \
--cc=mark.rutland@arm.com \
--cc=maxime.chevallier@bootlin.com \
--cc=nadavh@marvell.com \
--cc=robh+dt@kernel.org \
--cc=sebastian.hesselbarth@gmail.com \
--cc=thomas.petazzoni@bootlin.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).