Linux-Watchdog Archive on lore.kernel.org
 help / color / Atom feed
* [PATCH 0/3] add dual-boot support
@ 2019-08-21 15:52 Ivan Mikhaylov
  0 siblings, 0 replies; only message in thread
From: Ivan Mikhaylov @ 2019-08-21 15:52 UTC (permalink / raw)
  To: Wim Van Sebroeck, Guenter Roeck
  Cc: Joel Stanley, Andrew Jeffery, linux-watchdog, linux-arm-kernel,
	linux-aspeed, linux-kernel, Alexander Amelkin

ASPEED SoCs support dual-boot feature for SPI Flash.
When strapped appropriately, the SoC starts wdt2 (/dev/watchdog1)
and if within a minute it is not disabled, it goes off and reboots
the SoC from an alternate SPI Flash chip by changing CS0 controls
to actually drive CS1 line.

When booted from alternate chip, in order to access the main chip
at CS0, the user must reset the appropriate bit in the watchdog
hardware. There is no interface that would allow to do that from
an embedded firmware startup script.

This commit implements support for that feature:

* Enable 'alt-boot' option for wdt2

* Enable secondary SPI flash chip

* Make it possible to get access to the primary SPI flash chip at CS0
  after booting from the alternate chip at CS1. A sysfs interface is added
  to provide an easy way for embedded firmware startup scripts to clear
  the chip select bit to gain access to the primary flash chip in order
  to allow for recovery of its contents.

Ivan Mikhaylov (3):
  vesnin: add wdt2 section with alt-boot option
  vesnin: add secondary SPI flash chip
  watchdog/aspeed: add support for dual boot

 arch/arm/boot/dts/aspeed-bmc-opp-vesnin.dts | 12 +++++++++
 drivers/watchdog/aspeed_wdt.c               | 30 +++++++++++++++++++++
 2 files changed, 42 insertions(+)

-- 
2.20.1



^ permalink raw reply	[flat|nested] only message in thread

only message in thread, back to index

Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2019-08-21 15:52 [PATCH 0/3] add dual-boot support Ivan Mikhaylov

Linux-Watchdog Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-watchdog/0 linux-watchdog/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-watchdog linux-watchdog/ https://lore.kernel.org/linux-watchdog \
		linux-watchdog@vger.kernel.org linux-watchdog@archiver.kernel.org
	public-inbox-index linux-watchdog


Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-watchdog


AGPL code for this site: git clone https://public-inbox.org/ public-inbox