Re: [PATCH 8/8] phy: add driver for TI TUSB1210 ULPI PHY

[David Cohen <david.a.cohen@linux.intel.com>]

Hi Felipe,

[snip]

> diff --git a/drivers/usb/dwc3/dwc3-pci.c b/drivers/usb/dwc3/dwc3-pci.c
> index 8d95056..53902ea 100644
> --- a/drivers/usb/dwc3/dwc3-pci.c
> +++ b/drivers/usb/dwc3/dwc3-pci.c
> @@ -21,6 +21,7 @@
>  #include <linux/slab.h>
>  #include <linux/pci.h>
>  #include <linux/platform_device.h>
> +#include <linux/gpio/consumer.h>
>  
>  #include "platform_data.h"
>  
> @@ -35,6 +36,24 @@
>  
>  static int dwc3_pci_quirks(struct pci_dev *pdev)
>  {
> +	if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
> +	    pdev->device == PCI_DEVICE_ID_INTEL_BYT) {
> +		struct gpio_desc *gpio;
> +
> +		gpio = gpiod_get_index(&pdev->dev, "reset", 0);
> +		if (!IS_ERR(gpio)) {
> +			gpiod_direction_output(gpio, 0);
> +			gpiod_set_value_cansleep(gpio, 1);
> +			gpiod_put(gpio);
> +		}
> +		gpio = gpiod_get_index(&pdev->dev, "cs", 1);
> +		if (!IS_ERR(gpio)) {
> +			gpiod_direction_output(gpio, 0);
> +			gpiod_set_value_cansleep(gpio, 1);
> +			gpiod_put(gpio);
> +		}
> +	}
> +

A lot has been discussed in other branches of this thread.

But in resume, this is the last open point to make Heikki's proposal
good on my side. If you accept this ugly quirk (but necessary for
current BYT-CR products when ULPI bus enumerates phy), everything seems
good to me. If you don't accept, we need to figure out a way to get the
platform driver code back to give gpio to phy as platform data in a way
that it could live together with ULPI bus (BYT-CR needs the ULPI bus too).

Br, David

>  	if (pdev->vendor == PCI_VENDOR_ID_AMD &&
>  	    pdev->device == PCI_DEVICE_ID_AMD_NL_USB) {
>  		struct dwc3_platform_data pdata;