[PATCH 4/6] dt-bindings: interrupt-controller: RISC-V local interrupt controller docs

[Christoph Hellwig <hch@lst.de>]

From: Palmer Dabbelt <palmer@dabbelt.com>

This patch adds documentation on the RISC-V local interrupt controller,
which is a per-hart interrupt controller that manages all interrupts
entering a RISC-V hart.  This interrupt controller is present on all
RISC-V systems.

Signed-off-by: Palmer Dabbelt <palmer@dabbelt.com>
---
 .../interrupt-controller/riscv,cpu-intc.txt   | 41 +++++++++++++++++++
 1 file changed, 41 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt

diff --git a/Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt
new file mode 100644
index 000000000000..61900e2e3868
--- /dev/null
+++ b/Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt
@@ -0,0 +1,41 @@
+RISC-V Hart-Level Interrupt Controller (HLIC)
+---------------------------------------------
+
+RISC-V cores include Control Status Registers (CSRs) which are local to each
+hart and can be read or written by software. Some of these CSRs are used to
+control local interrupts connected to the core.  Every interrupt is ultimately
+routed through a hart's HLIC before it interrupts that hart.
+
+The RISC-V supervisor ISA manual specifies three interrupt sources that are
+attached to every HLIC: software interrupts, the timer interrupt, and external
+interrupts.  Software interrupts are used to send IPIs between cores.  The
+timer interrupt comes from an architecturally mandated real-time timer that is
+controller via SBI calls and CSR reads.  External interrupts connect all other
+device interrupts to the HLIC, which are routed via the platform-level
+interrupt controller (PLIC).
+
+All RISC-V systems that conform to the supervisor ISA specification are
+required to have a HLIC with these three interrupt sources present.  Since the
+interrupt map is defined by the ISA it's not listed in the HLIC's device tree
+entry, though external interrupt controllers (like the PLIC, for example) will
+need to define how their interrupts map to the relevant HLICs.
+
+Required properties:
+- compatible : "riscv,cpu-intc"
+- #interrupt-cells : should be <1>
+- interrupt-controller : Identifies the node as an interrupt controller
+
+Furthermore, this interrupt-controller MUST be embedded inside the cpu
+definition of the hart whose CSRs control these local interrupts.
+
+An example device tree entry for a HLIC is show below.
+
+	cpu1: cpu@1 {
+		compatible = "riscv";
+		...
+		cpu1-intc: interrupt-controller {
+			#interrupt-cells = <1>;
+			compatible = "riscv,cpu-intc";
+			interrupt-controller;
+		};
+	};
-- 
2.18.0