Re: B53 DSA switch problem on Banana Pi-R1 on Fedora 26

[Gerhard Wiesinger <lists@wiesinger.com>]

On 22.05.2018 22:42, Florian Fainelli wrote:
> On 05/22/2018 01:16 PM, Andrew Lunn wrote:
>>> Planned network structure will be as with 4.7.x kernels:
>>>
>>> br0 <=> eth0.101 <=> eth0 (vlan 101 tagged) <=> lan 1-lan4 (vlan 101
>>> untagged pvid)
>>>
>>> br1 <=> eth0.102 <=> eth0 (vlan 102 tagged) <=> wan (vlan 102 untagged pvid)
>> Do you even need these vlans?
> Yes, remember, b53 does not currently turn on Broadcom tags, so the only
> way to segregate traffic is to have VLANs for that.
>
>> Are you doing this for port separation? To keep lan1-4 traffic
>> separate from wan? DSA does that by default, no vlan needed.
>>
>> So you can just do
>>
>> ip link add name br0 type bridge
>> ip link set dev br0 up
>> ip link set dev lan1 master br0
>> ip link set dev lan2 master br0
>> ip link set dev lan3 master br0
>> ip link set dev lan4 master br0
>>
>> and use interface wan directly, no bridge needed.
> That would work once Broadcom tags are turned on which requires turning
> on managed mode, which requires work that I have not been able to get
> done :)

Setup with swconfig:

#!/usr/bin/bash


INTERFACE=eth0

# Delete all IP addresses and get link up
ip addr flush dev ${INTERFACE}
ip link set ${INTERFACE} up

# Lamobo R1 aka BPi R1 Routerboard
#
# Speaker | LAN1 | LAN2 | LAN3 | LAN4 || LAN5 | HDMI
# SW-Port |  P2  |  P1  |  P0  |  P4  ||  P3  |
# VLAN    |  11  |  12  |  13  |  14  ||ALL(t)|
#
# Switch-Port P8 - ALL(t) boards internal CPU Port

# Setup switch
swconfig dev ${INTERFACE} set reset 1
swconfig dev ${INTERFACE} set enable_vlan 1
swconfig dev ${INTERFACE} vlan 101 set ports '3 8t'
swconfig dev ${INTERFACE} vlan 102 set ports '4 0 1 2 8t'
swconfig dev ${INTERFACE} set apply 1

How to achieve this setup CURRENTLY with DSA?

And in the future (time plan)?

Thank you.

Ciao,
Gerhard