Netdev Archive on lore.kernel.org
 help / color / Atom feed
From: Alexandru Ardelean <alexandru.ardelean@analog.com>
To: <netdev@vger.kernel.org>, <devicetree@vger.kernel.org>,
	<linux-kernel@vger.kernel.org>
Cc: <davem@davemloft.net>, <robh+dt@kernel.org>,
	<mark.rutland@arm.com>, <f.fainelli@gmail.com>,
	<hkallweit1@gmail.com>, <andrew@lunn.ch>,
	Alexandru Ardelean <alexandru.ardelean@analog.com>
Subject: [PATCH v5 03/13] net: phy: adin: add support for interrupts
Date: Fri, 16 Aug 2019 16:10:01 +0300
Message-ID: <20190816131011.23264-4-alexandru.ardelean@analog.com> (raw)
In-Reply-To: <20190816131011.23264-1-alexandru.ardelean@analog.com>

This change hooks link-status-change interrupts to phylib.

Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
---
 drivers/net/phy/adin.c | 36 ++++++++++++++++++++++++++++++++++++
 1 file changed, 36 insertions(+)

diff --git a/drivers/net/phy/adin.c b/drivers/net/phy/adin.c
index fc0148ba4b94..f4ee611e33df 100644
--- a/drivers/net/phy/adin.c
+++ b/drivers/net/phy/adin.c
@@ -14,11 +14,43 @@
 #define PHY_ID_ADIN1200				0x0283bc20
 #define PHY_ID_ADIN1300				0x0283bc30
 
+#define ADIN1300_INT_MASK_REG			0x0018
+#define   ADIN1300_INT_MDIO_SYNC_EN		BIT(9)
+#define   ADIN1300_INT_ANEG_STAT_CHNG_EN	BIT(8)
+#define   ADIN1300_INT_ANEG_PAGE_RX_EN		BIT(6)
+#define   ADIN1300_INT_IDLE_ERR_CNT_EN		BIT(5)
+#define   ADIN1300_INT_MAC_FIFO_OU_EN		BIT(4)
+#define   ADIN1300_INT_RX_STAT_CHNG_EN		BIT(3)
+#define   ADIN1300_INT_LINK_STAT_CHNG_EN	BIT(2)
+#define   ADIN1300_INT_SPEED_CHNG_EN		BIT(1)
+#define   ADIN1300_INT_HW_IRQ_EN		BIT(0)
+#define ADIN1300_INT_MASK_EN	\
+	(ADIN1300_INT_LINK_STAT_CHNG_EN | ADIN1300_INT_HW_IRQ_EN)
+#define ADIN1300_INT_STATUS_REG			0x0019
+
 static int adin_config_init(struct phy_device *phydev)
 {
 	return genphy_config_init(phydev);
 }
 
+static int adin_phy_ack_intr(struct phy_device *phydev)
+{
+	/* Clear pending interrupts */
+	int rc = phy_read(phydev, ADIN1300_INT_STATUS_REG);
+
+	return rc < 0 ? rc : 0;
+}
+
+static int adin_phy_config_intr(struct phy_device *phydev)
+{
+	if (phydev->interrupts == PHY_INTERRUPT_ENABLED)
+		return phy_set_bits(phydev, ADIN1300_INT_MASK_REG,
+				    ADIN1300_INT_MASK_EN);
+
+	return phy_clear_bits(phydev, ADIN1300_INT_MASK_REG,
+			      ADIN1300_INT_MASK_EN);
+}
+
 static struct phy_driver adin_driver[] = {
 	{
 		PHY_ID_MATCH_MODEL(PHY_ID_ADIN1200),
@@ -26,6 +58,8 @@ static struct phy_driver adin_driver[] = {
 		.config_init	= adin_config_init,
 		.config_aneg	= genphy_config_aneg,
 		.read_status	= genphy_read_status,
+		.ack_interrupt	= adin_phy_ack_intr,
+		.config_intr	= adin_phy_config_intr,
 		.resume		= genphy_resume,
 		.suspend	= genphy_suspend,
 	},
@@ -35,6 +69,8 @@ static struct phy_driver adin_driver[] = {
 		.config_init	= adin_config_init,
 		.config_aneg	= genphy_config_aneg,
 		.read_status	= genphy_read_status,
+		.ack_interrupt	= adin_phy_ack_intr,
+		.config_intr	= adin_phy_config_intr,
 		.resume		= genphy_resume,
 		.suspend	= genphy_suspend,
 	},
-- 
2.20.1


  parent reply index

Thread overview: 17+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-08-16 13:09 [PATCH v5 00/13] net: phy: adin: add support for Analog Devices PHYs Alexandru Ardelean
2019-08-16 13:09 ` [PATCH v5 01/13] " Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 02/13] net: phy: adin: hook genphy_{suspend,resume} into the driver Alexandru Ardelean
2019-08-16 13:10 ` Alexandru Ardelean [this message]
2019-08-16 13:10 ` [PATCH v5 04/13] net: phy: adin: add {write,read}_mmd hooks Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 05/13] net: phy: adin: configure RGMII/RMII/MII modes on config Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 06/13] net: phy: adin: make RGMII internal delays configurable Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 07/13] net: phy: adin: make RMII fifo depth configurable Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 08/13] net: phy: adin: add support MDI/MDIX/Auto-MDI selection Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 09/13] net: phy: adin: add EEE translation layer from Clause 45 to Clause 22 Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 10/13] net: phy: adin: implement PHY subsystem software reset Alexandru Ardelean
2019-08-16 13:19   ` Andrew Lunn
2019-08-16 13:10 ` [PATCH v5 11/13] net: phy: adin: implement downshift configuration via phy-tunable Alexandru Ardelean
2019-08-16 13:10 ` [PATCH v5 12/13] net: phy: adin: add ethtool get_stats support Alexandru Ardelean
2019-08-16 13:24   ` Andrew Lunn
2019-08-16 13:10 ` [PATCH v5 13/13] dt-bindings: net: add bindings for ADIN PHY driver Alexandru Ardelean
2019-08-16 18:57 ` [PATCH v5 00/13] net: phy: adin: add support for Analog Devices PHYs David Miller

Reply instructions:

You may reply publically to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20190816131011.23264-4-alexandru.ardelean@analog.com \
    --to=alexandru.ardelean@analog.com \
    --cc=andrew@lunn.ch \
    --cc=davem@davemloft.net \
    --cc=devicetree@vger.kernel.org \
    --cc=f.fainelli@gmail.com \
    --cc=hkallweit1@gmail.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=mark.rutland@arm.com \
    --cc=netdev@vger.kernel.org \
    --cc=robh+dt@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Netdev Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/netdev/0 netdev/git/0.git
	git clone --mirror https://lore.kernel.org/netdev/1 netdev/git/1.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 netdev netdev/ https://lore.kernel.org/netdev \
		netdev@vger.kernel.org
	public-inbox-index netdev

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.netdev


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git