[virtio-dev] RE: [PATCH 10/11] transport-pci: Use driver notification PCI capability

[Parav Pandit <parav@nvidia.com>]

> From: Michael S. Tsirkin <mst@redhat.com>
> Sent: Wednesday, April 12, 2023 12:31 AM
> 
> On Fri, Mar 31, 2023 at 01:58:33AM +0300, Parav Pandit wrote:
> > PCI devices support memory BAR regions for performant driver
> > notifications using the notification capability.
> > Enable transitional MMR devices to use it in simpler manner.
> >
> > Co-developed-by: Satananda Burla <sburla@marvell.com>
> > Signed-off-by: Parav Pandit <parav@nvidia.com>
> > ---
> >  transport-pci.tex | 28 ++++++++++++++++++++++++++++
> >  1 file changed, 28 insertions(+)
> >
> > diff --git a/transport-pci.tex b/transport-pci.tex index
> > 55a6aa0..4fd9898 100644
> > --- a/transport-pci.tex
> > +++ b/transport-pci.tex
> > @@ -763,6 +763,34 @@ \subsubsection{Notification structure
> > layout}\label{sec:Virtio Transport Options  cap.length >=
> > queue_notify_off * notify_off_multiplier + 4  \end{lstlisting}
> >
> > +\paragraph{Transitional MMR Interface: A note on Notification
> > +Capability} \label{sec:Virtio Transport Options / Virtio Over PCI Bus
> > +/ Virtio Structure PCI Capabilities / Notification capability /
> > +Transitional MMR Interface}
> > +
> > +The transitional MMR device benefits from receiving driver
> > +notifications at the Queue Notification address offered using the
> > +notification capability, rather than via the memory mapped legacy
> > +QueueNotify configuration register.
> > +
> > +Transitional MMR device uses same Queue Notification address within a
> > +BAR for all virtqueues:
> > +\begin{lstlisting}
> > +cap.offset
> > +\end{lstlisting}
> > +
> > +The transitional MMR device MUST support Queue Notification address
> > +within a BAR for all virtqueues at:
> > +\begin{lstlisting}
> > +cap.offset
> > +\end{lstlisting}
> > +
> > +The transitional MMR driver that wants to use driver notifications
> > +offered using notification capability MUST use same Queue
> > +Notification address within a BAR for all virtqueues at:
> > +
> > +\begin{lstlisting}
> > +cap.offset
> > +\end{lstlisting}
> > +
> Why? What exactly is going on here? legacy drivers will not do this.

Legacy driver does in the q notify register that was sandwitched in between of slow configuration registers.
This is the notification offset for the hypervisor driver to perform the notification on behalf of the guest driver so that the acceleration available for the non-transitional device can be utilized here as well.


---------------------------------------------------------------------
To unsubscribe, e-mail: virtio-dev-unsubscribe@lists.oasis-open.org
For additional commands, e-mail: virtio-dev-help@lists.oasis-open.org