From: Matt Roper <matthew.d.roper@intel.com>
To: intel-gfx@lists.freedesktop.org
Subject: Re: [Intel-gfx] [PATCH v2 16/22] drm/i915/rkl: Don't try to access transcoder D
Date: Wed, 6 May 2020 13:34:21 -0700 [thread overview]
Message-ID: <20200506203421.GY188376@mdroper-desk1.amr.corp.intel.com> (raw)
In-Reply-To: <20200504225227.464666-17-matthew.d.roper@intel.com>
On Mon, May 04, 2020 at 03:52:21PM -0700, Matt Roper wrote:
> There are a couple places in our driver that loop over transcoders A..D
> for gen11+; since RKL only has three pipes/transcoders, this can lead to
> unclaimed register reads/writes. We should add checks for transcoder
> existence where appropriate.
>
> Cc: Aditya Swarup <aditya.swarup@intel.com>
> Signed-off-by: Matt Roper <matthew.d.roper@intel.com>
> ---
> drivers/gpu/drm/i915/display/intel_display.c | 3 +++
> drivers/gpu/drm/i915/i915_irq.c | 6 ++++++
> 2 files changed, 9 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_display.c b/drivers/gpu/drm/i915/display/intel_display.c
> index fcfc3812ef28..2eeafda82188 100644
> --- a/drivers/gpu/drm/i915/display/intel_display.c
> +++ b/drivers/gpu/drm/i915/display/intel_display.c
> @@ -11007,6 +11007,9 @@ static bool bxt_get_dsi_transcoder_state(struct intel_crtc *crtc,
> else
> cpu_transcoder = TRANSCODER_DSI_C;
>
> + if (!HAS_TRANSCODER(dev_priv, cpu_transcoder))
> + continue;
> +
It looks like this hunk wound up in the wrong function after a conflict
resolution. It was supposed to be in icl_get_trans_port_sync_config()
instead (this BXT function doesn't execute on gen >= 11).
Matt
> power_domain = POWER_DOMAIN_TRANSCODER(cpu_transcoder);
> drm_WARN_ON(dev, *power_domain_mask & BIT_ULL(power_domain));
>
> diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c
> index 622986759ec6..1381cb530c2f 100644
> --- a/drivers/gpu/drm/i915/i915_irq.c
> +++ b/drivers/gpu/drm/i915/i915_irq.c
> @@ -2849,6 +2849,9 @@ static void gen11_display_irq_reset(struct drm_i915_private *dev_priv)
> for (trans = TRANSCODER_A; trans <= TRANSCODER_D; trans++) {
> enum intel_display_power_domain domain;
>
> + if (!HAS_TRANSCODER(dev_priv, trans))
> + continue;
> +
> domain = POWER_DOMAIN_TRANSCODER(trans);
> if (!intel_display_power_is_enabled(dev_priv, domain))
> continue;
> @@ -3399,6 +3402,9 @@ static void gen8_de_irq_postinstall(struct drm_i915_private *dev_priv)
> for (trans = TRANSCODER_A; trans <= TRANSCODER_D; trans++) {
> enum intel_display_power_domain domain;
>
> + if (!HAS_TRANSCODER(dev_priv, trans))
> + continue;
> +
> domain = POWER_DOMAIN_TRANSCODER(trans);
> if (!intel_display_power_is_enabled(dev_priv, domain))
> continue;
> --
> 2.24.1
>
--
Matt Roper
Graphics Software Engineer
VTT-OSGC Platform Enablement
Intel Corporation
(916) 356-2795
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
next prev parent reply other threads:[~2020-05-06 20:34 UTC|newest]
Thread overview: 53+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-05-04 22:52 [Intel-gfx] [PATCH v2 00/22] Introduce Rocket Lake Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 01/22] drm/i915/rkl: Add RKL platform info and PCI ids Matt Roper
2020-05-07 11:18 ` Srivatsa, Anusha
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 02/22] x86/gpu: add RKL stolen memory support Matt Roper
2020-05-06 11:51 ` Srivatsa, Anusha
2020-05-19 23:57 ` Lucas De Marchi
2020-05-20 9:30 ` Borislav Petkov
2020-05-20 17:49 ` Lucas De Marchi
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 03/22] drm/i915/rkl: Re-use TGL GuC/HuC firmware Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 04/22] drm/i915/rkl: Load DMC firmware for Rocket Lake Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 05/22] drm/i915/rkl: Add PCH support Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 06/22] drm/i915/rkl: Update memory bandwidth parameters Matt Roper
2020-05-07 12:24 ` Ville Syrjälä
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 07/22] drm/i915/rkl: Limit number of universal planes to 5 Matt Roper
2020-05-07 12:10 ` Ville Syrjälä
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 08/22] drm/i915/rkl: Add power well support Matt Roper
2020-05-05 4:50 ` Anshuman Gupta
2020-05-05 14:39 ` Matt Roper
2020-05-05 16:09 ` Imre Deak
2020-05-06 12:13 ` Anshuman Gupta
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 09/22] drm/i915/rkl: Program BW_BUDDY0 registers instead of BW_BUDDY1/2 Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 10/22] drm/i915/rkl: RKL only uses PHY_MISC for PHY's A and B Matt Roper
2020-05-06 13:49 ` Srivatsa, Anusha
2020-05-06 16:49 ` Matt Roper
2020-05-07 11:22 ` Srivatsa, Anusha
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 11/22] drm/i915/rkl: Handle new DPCLKA_CFGCR0 layout Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 12/22] drm/i915/rkl: Check proper SDEISR bits for TC1 and TC2 outputs Matt Roper
2020-05-07 11:38 ` Srivatsa, Anusha
2020-05-07 11:59 ` Ville Syrjälä
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 13/22] drm/i915/rkl: Setup ports/phys Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 14/22] drm/i915/rkl: provide port/phy mapping for vbt Matt Roper
2020-05-07 12:04 ` Ville Syrjälä
2020-05-07 18:05 ` Matt Roper
2020-05-08 9:44 ` Ville Syrjälä
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 15/22] drm/i915/rkl: Add DDC pin mapping Matt Roper
2020-05-06 9:19 ` Srivatsa, Anusha
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 16/22] drm/i915/rkl: Don't try to access transcoder D Matt Roper
2020-05-06 20:34 ` Matt Roper [this message]
2020-05-06 21:21 ` [Intel-gfx] [PATCH v3 " Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 17/22] drm/i915/rkl: Don't try to read out DSI transcoders Matt Roper
2020-05-07 11:58 ` Ville Syrjälä
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 18/22] drm/i915/rkl: Handle comp master/slave relationships for PHYs Matt Roper
2020-05-06 9:20 ` Srivatsa, Anusha
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 19/22] drm/i915/rkl: Add DPLL4 support Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 20/22] drm/i915/rkl: Handle HTI Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 21/22] drm/i915/rkl: Disable PSR2 Matt Roper
2020-05-04 22:52 ` [Intel-gfx] [PATCH v2 22/22] drm/i915/rkl: Add initial workarounds Matt Roper
2020-05-04 23:10 ` [Intel-gfx] ✗ Fi.CI.CHECKPATCH: warning for Introduce Rocket Lake (rev4) Patchwork
2020-05-04 23:33 ` [Intel-gfx] ✓ Fi.CI.BAT: success " Patchwork
2020-05-05 13:35 ` [Intel-gfx] ✗ Fi.CI.IGT: failure " Patchwork
2020-05-06 22:31 ` [Intel-gfx] ✗ Fi.CI.CHECKPATCH: warning for Introduce Rocket Lake (rev5) Patchwork
2020-05-06 22:55 ` [Intel-gfx] ✓ Fi.CI.BAT: success " Patchwork
2020-05-07 2:12 ` [Intel-gfx] ✓ Fi.CI.IGT: " Patchwork
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200506203421.GY188376@mdroper-desk1.amr.corp.intel.com \
--to=matthew.d.roper@intel.com \
--cc=intel-gfx@lists.freedesktop.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).