Re: [net-next v2 17/71] myri*: Move the Myricom drivers

[Jeff Kirsher <jeffrey.t.kirsher@intel.com>]

[-- Attachment #1: Type: text/plain, Size: 2391 bytes --]

On Mon, 2011-08-01 at 10:09 -0700, Jon Mason wrote:
> On Sat, Jul 30, 2011 at 10:26 PM, Jeff Kirsher
> <jeffrey.t.kirsher@intel.com> wrote:
> > Move the Myricom drivers into drivers/net/ethernet/myricom/ and make
> > the necessary Kconfig and Makefile changes.
> 
> Acked-by: Jon Mason <mason@myri.com>
> 
> > CC: Andrew Gallatin <gallatin@myri.com>
> > CC: Brice Goglin <brice@myri.com>
> > Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com> 

Jon-

I made some minor changes to the Kconfig based on feedback from others
on other Kconfig's which made sense to apply to the other driver
Kconfig's.  Here is the Kconfig:

+config NET_VENDOR_MYRI
+       bool "Myricom devices"
+       depends on PCI && INET
+       ---help---
+         If you have a network (Ethernet) card belonging to this class,
say
+         Y and read the Ethernet-HOWTO, available from
+         <http://www.tldp.org/docs.html#howto>.
+
+         Note that the answer to this question doesn't directly affect
the
+         kernel: saying N will just cause the configurator to skip all
+         the questions about Myricom cards. If you say Y, you will be
asked for
+         your specific card in the following questions.
+
+if NET_VENDOR_MYRI
+
+config MYRI10GE
+       tristate "Myricom Myri-10G Ethernet support"
+       depends on PCI && INET
+       select FW_LOADER
+       select CRC32
+       select INET_LRO
+       ---help---
+         This driver supports Myricom Myri-10G Dual Protocol interface
in
+         Ethernet mode. If the eeprom on your board is not recent
enough,
+         you will need a newer firmware image.
+         You may get this image or more information, at:
+
+         <http://www.myri.com/scs/download-Myri10GE.html>
+
+         To compile this driver as a module, choose M here. The module
+         will be called myri10ge.
+
+config MYRI10GE_DCA
+       bool "Direct Cache Access (DCA) Support"
+       default y
+       depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m)
+       ---help---
+         Say Y here if you want to use Direct Cache Access (DCA) in the
+         driver.  DCA is a method for warming the CPU cache before data
+         is used, with the intent of lessening the impact of cache
misses.
+
+endif # NET_VENDOR_MYRI

Let me know if these changes are ok and I can add your ACK.

[-- Attachment #2: This is a digitally signed message part --]
[-- Type: application/pgp-signature, Size: 490 bytes --]