From: Vladimir Zapolskiy <vz-ChpfBGZJDbMAvxtiuMwx3w@public.gmane.org> To: Sylvain Lemieux <slemieux.tyco-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org> Cc: devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org, "linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org" <linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org> Subject: Re: [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx Date: Wed, 10 Feb 2016 02:19:03 +0200 [thread overview] Message-ID: <56BA81F7.4080006@mleia.com> (raw) In-Reply-To: <loom.20160209T215103-78-eS7Uydv5nfjZ+VzJOa5vwg@public.gmane.org> Hi Sylvain, On 09.02.2016 23:01, Sylvain Lemieux wrote: > Vladimir Zapolskiy <vz@...> writes: >> >> This changeset adds common clock framework driver for NXP LPC32xx >> boards. > > Hi Vladimir, > > Just to let you know that we did some testing using this changeset; > I installed patches 4 to 7, 10 & 11 on top of 4.5-rc1. > > I was able to run our software (SIC1 interrupt sources disable) > without any problem a custom LPC32xx board. this is a known issue, and I hope it will be fixed in upstream in v4.6, the required changes in irqchip and gpiochip drivers were sent for review some time ago, a bit more work is needed to Also 2-3 more clean-up changes in USB host and gadget drivers are done locally (no more need to configure clocks out of the common clock framework), but not yet submitted, will do it tomorrow. > We did not get any problem with the clock signals we are using. > Thank you for testing, I'm going to add your Tested-by tag (if you don't mind) and submit a PR to ARM maintainers shortly. >> Vladimir Zapolskiy (11): >> dt-bindings: clock: add description of LPC32xx clock controller >> dt-bindings: clock: add description of LPC32xx USB clock controller >> dt-bindings: clock: add NXP LPC32xx clock list for consumers >> arm: dts: lpc32xx: add device nodes for external oscillators >> arm: dts: lpc32xx: add clock controller device node >> arm: dts: lpc32xx: add clock properties to device nodes >> arm: dts: lpc32xx: add USB clock controller >> clk: lpc18xx: add NXP specific common clock framework selection >> clk: lpc32xx: add common clock framework driver >> arm: lpc32xx: switch to common clock framework >> arm: dts: lpc32xx: remove clock frequency property from UART device >> nodes > > With best wishes, Vladimir -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org More majordomo info at http://vger.kernel.org/majordomo-info.html
WARNING: multiple messages have this Message-ID (diff)
From: vz@mleia.com (Vladimir Zapolskiy) To: linux-arm-kernel@lists.infradead.org Subject: [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx Date: Wed, 10 Feb 2016 02:19:03 +0200 [thread overview] Message-ID: <56BA81F7.4080006@mleia.com> (raw) In-Reply-To: <loom.20160209T215103-78@post.gmane.org> Hi Sylvain, On 09.02.2016 23:01, Sylvain Lemieux wrote: > Vladimir Zapolskiy <vz@...> writes: >> >> This changeset adds common clock framework driver for NXP LPC32xx >> boards. > > Hi Vladimir, > > Just to let you know that we did some testing using this changeset; > I installed patches 4 to 7, 10 & 11 on top of 4.5-rc1. > > I was able to run our software (SIC1 interrupt sources disable) > without any problem a custom LPC32xx board. this is a known issue, and I hope it will be fixed in upstream in v4.6, the required changes in irqchip and gpiochip drivers were sent for review some time ago, a bit more work is needed to Also 2-3 more clean-up changes in USB host and gadget drivers are done locally (no more need to configure clocks out of the common clock framework), but not yet submitted, will do it tomorrow. > We did not get any problem with the clock signals we are using. > Thank you for testing, I'm going to add your Tested-by tag (if you don't mind) and submit a PR to ARM maintainers shortly. >> Vladimir Zapolskiy (11): >> dt-bindings: clock: add description of LPC32xx clock controller >> dt-bindings: clock: add description of LPC32xx USB clock controller >> dt-bindings: clock: add NXP LPC32xx clock list for consumers >> arm: dts: lpc32xx: add device nodes for external oscillators >> arm: dts: lpc32xx: add clock controller device node >> arm: dts: lpc32xx: add clock properties to device nodes >> arm: dts: lpc32xx: add USB clock controller >> clk: lpc18xx: add NXP specific common clock framework selection >> clk: lpc32xx: add common clock framework driver >> arm: lpc32xx: switch to common clock framework >> arm: dts: lpc32xx: remove clock frequency property from UART device >> nodes > > With best wishes, Vladimir
next prev parent reply other threads:[~2016-02-10 0:19 UTC|newest] Thread overview: 67+ messages / expand[flat|nested] mbox.gz Atom feed top 2015-11-20 1:05 [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 02/11] dt-bindings: clock: add description of LPC32xx USB clock controller Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 16:41 ` Rob Herring 2015-11-20 16:41 ` Rob Herring 2015-11-20 18:14 ` Vladimir Zapolskiy 2015-11-20 18:14 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 03/11] dt-bindings: clock: add NXP LPC32xx clock list for consumers Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 13:56 ` Arnd Bergmann 2015-11-20 13:56 ` Arnd Bergmann 2015-11-20 13:56 ` Arnd Bergmann 2015-11-20 17:58 ` Vladimir Zapolskiy 2015-11-20 17:58 ` Vladimir Zapolskiy 2015-11-20 21:07 ` Arnd Bergmann 2015-11-20 21:07 ` Arnd Bergmann 2015-11-21 18:53 ` Vladimir Zapolskiy 2015-11-21 18:53 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 04/11] arm: dts: lpc32xx: add device nodes for external oscillators Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 05/11] arm: dts: lpc32xx: add clock controller device node Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy [not found] ` <1447981511-29653-1-git-send-email-vz-ChpfBGZJDbMAvxtiuMwx3w@public.gmane.org> 2015-11-20 1:05 ` [PATCH 01/11] dt-bindings: clock: add description of LPC32xx clock controller Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 13:58 ` Arnd Bergmann 2015-11-20 13:58 ` Arnd Bergmann 2015-11-20 18:01 ` Vladimir Zapolskiy 2015-11-20 18:01 ` Vladimir Zapolskiy 2015-11-20 18:01 ` Vladimir Zapolskiy 2015-11-20 20:03 ` Arnd Bergmann 2015-11-20 20:03 ` Arnd Bergmann 2015-11-20 1:05 ` [PATCH 06/11] arm: dts: lpc32xx: add clock properties to device nodes Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 07/11] arm: dts: lpc32xx: add USB clock controller Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 08/11] clk: lpc18xx: add NXP specific common clock framework selection Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-22 20:38 ` Joachim Eastwood 2015-11-22 20:38 ` Joachim Eastwood 2015-11-22 20:38 ` Joachim Eastwood 2015-11-20 1:05 ` [PATCH 11/11] arm: dts: lpc32xx: remove clock frequency property from UART device nodes Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 09/11] clk: lpc32xx: add common clock framework driver Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2015-11-20 14:04 ` Arnd Bergmann 2015-11-20 14:04 ` Arnd Bergmann 2015-11-20 18:07 ` Vladimir Zapolskiy 2015-11-20 18:07 ` Vladimir Zapolskiy 2015-11-20 18:07 ` Vladimir Zapolskiy 2015-11-20 20:20 ` Arnd Bergmann 2015-11-20 20:20 ` Arnd Bergmann 2015-11-29 13:00 ` Vladimir Zapolskiy 2015-11-29 13:00 ` Vladimir Zapolskiy 2015-11-20 1:05 ` [PATCH 10/11] arm: lpc32xx: switch to common clock framework Vladimir Zapolskiy 2015-11-20 1:05 ` Vladimir Zapolskiy 2016-02-09 21:01 ` [PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx Sylvain Lemieux [not found] ` <loom.20160209T215103-78-eS7Uydv5nfjZ+VzJOa5vwg@public.gmane.org> 2016-02-10 0:19 ` Vladimir Zapolskiy [this message] 2016-02-10 0:19 ` Vladimir Zapolskiy [not found] ` <56BA81F7.4080006-ChpfBGZJDbMAvxtiuMwx3w@public.gmane.org> 2016-02-10 14:25 ` Sylvain Lemieux 2016-02-10 14:25 ` Sylvain Lemieux
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=56BA81F7.4080006@mleia.com \ --to=vz-chpfbgzjdbmavxtiumwx3w@public.gmane.org \ --cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \ --cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \ --cc=slemieux.tyco-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.