From: Krzysztof Kozlowski <krzk@kernel.org>
To: Jonathan Bakker <xc-racer2@live.ca>
Cc: kgene@kernel.org, robh+dt@kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-samsung-soc@vger.kernel.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org
Subject: Re: [PATCH v2 00/18] S5PV210 and Aries DTS improvements
Date: Mon, 4 May 2020 17:15:08 +0200 [thread overview]
Message-ID: <20200504151508.GA3205@kozik-lap> (raw)
In-Reply-To: <BN6PR04MB066033FD7FF6E5C37747C7A2A3AB0@BN6PR04MB0660.namprd04.prod.outlook.com>
On Fri, May 01, 2020 at 04:50:01PM -0700, Jonathan Bakker wrote:
> This patchset makes several improvements to Aries devices which are
> based on S5PV210. Several pulls on GPIOs were incorrect/not specified,
> sleep GPIO configurations have been added, and more devices have been
> added.
>
> Touching the common S5PV210 DTSI are the addition of the ADC node
> as well as fixes to the FIMC definitions and a sleep GPIO helper
> added. The GPI gpio node name has been corrected.
>
> The patches have been tested on both a GT-i9000 as well as an
> SGH-T959P and both can now suspend/resume properly.
>
> Changes from v1:
> - Correct ADC node name to match reg
> - Restore removed regulator suspend state
> - Split commit adding support for new devices into separate commits
> for each device
> - Add note where sleep gpio cfgs come from
> - Ensure subject of all patches matches subsystem
> - Add patch correcting GPI node name
>
>
> Jonathan Bakker (17):
> ARM: dts: s5pv210: Add helper define for sleep gpio config
> ARM: dts: s5pv210: Add sleep GPIO configuration for fascinate4g
> ARM: dts: s5pv210: Add sleep GPIO configuration for galaxys
> ARM: dts: s5pv210: Set keep-power-in-suspend for SDHCI1 on aries
> ARM: dts: s5pv210: Disable pulls on GPIO i2c adapters for aries
> ARM: dts: s5pv210: Add WM8994 support to aries boards
> ARM: dts: s5pv210: Add FSA9480 support to Aries boards
> ARM: dts: s5pv210: Add touchkey support to aries boards
> ARM: dts: s5pv210: Add panel support to aries boards
> ARM: dts: s5pv210: Add remaining i2c-gpio adapters to aries
> ARM: dts: s5pv210: Disable pull for vibrator ena GPIO on aries
> ARM: dts: s5pv210: Add an ADC node
> ARM: dts: s5pv210: Enable ADC on aries boards
> ARM: dts: s5pv210: Assign clocks to MMC devices on aries
> ARM: dts: s5pv210: Correct FIMC definitions
> ARM: dts: s5pv210: Set MAX8998 GPIO pulls on aries
> ARM: dts: s5pv210: Correct gpi gpio node name
>
> Paweł Chmiel (1):
> ARM: dts: s5pv210: Add si470x fmradio to galaxys
>
Nice job!
Thanks, I applied entire set.
Best regards,
Krzysztof
next prev parent reply other threads:[~2020-05-04 15:15 UTC|newest]
Thread overview: 46+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <20200426183604.28494-1-xc-racer2@live.ca>
2020-04-26 18:35 ` [PATCH 01/13] arm: dts: s5pv210: Add helper define for sleep gpio config Jonathan Bakker
2020-04-26 18:35 ` [PATCH 02/13] arm: dts: s5pv210: fascinate4g: Add sleep GPIO configuration Jonathan Bakker
2020-04-28 10:02 ` Krzysztof Kozlowski
2020-04-28 23:49 ` Jonathan Bakker
2020-05-01 13:10 ` Krzysztof Kozlowski
2020-04-26 18:35 ` [PATCH 03/13] arm: dts: s5pv210: galaxys: " Jonathan Bakker
2020-04-26 18:35 ` [PATCH 04/13] arm: dts: s5pv210: aries: Set keep-power-in-suspend for SDHCI1 Jonathan Bakker
2020-04-26 18:35 ` [PATCH 05/13] arm: dts: s5pv210: aries: Disable pulls on GPIO i2c adapters Jonathan Bakker
2020-04-26 18:35 ` [PATCH 06/13] arm: dts: s5pv210: aries: Add support for more devices Jonathan Bakker
2020-04-28 10:20 ` Krzysztof Kozlowski
2020-04-28 23:32 ` Jonathan Bakker
2020-05-01 13:31 ` Krzysztof Kozlowski
2020-05-01 19:43 ` Jonathan Bakker
2020-04-26 18:35 ` [PATCH 07/13] arm: dts: s5pv210: galaxys: Add si470x fmradio Jonathan Bakker
2020-04-26 18:35 ` [PATCH 08/13] arm: dts: s5pv210: aries: Disable pull for vibrator ena GPIO Jonathan Bakker
2020-04-26 18:36 ` [PATCH 09/13] arm: dts: s5pv210: Add an ADC node Jonathan Bakker
2020-04-28 10:26 ` Krzysztof Kozlowski
2020-04-28 22:27 ` Jonathan Bakker
2020-04-26 18:36 ` [PATCH 10/13] arm: dts: s5pv210: aries: Enable " Jonathan Bakker
2020-04-28 10:29 ` Krzysztof Kozlowski
2020-04-28 22:26 ` Jonathan Bakker
2020-04-26 18:36 ` [PATCH 11/13] arm: dts: s5pv210: Assign clocks to MMC devices Jonathan Bakker
2020-04-26 18:36 ` [PATCH 12/13] arm: dts: s5pv210: Correct FIMC definitions Jonathan Bakker
2020-04-28 10:32 ` Krzysztof Kozlowski
2020-04-28 22:31 ` Jonathan Bakker
2020-04-26 18:36 ` [PATCH 13/13] arm: dts: s5pv210: aries: Set MAX8998 GPIO pulls Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 00/18] S5PV210 and Aries DTS improvements Jonathan Bakker
2020-05-04 15:15 ` Krzysztof Kozlowski [this message]
[not found] ` <20200501235019.24022-1-xc-racer2@live.ca>
2020-05-01 23:50 ` [PATCH v2 01/18] ARM: dts: s5pv210: Add helper define for sleep gpio config Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 02/18] ARM: dts: s5pv210: Add sleep GPIO configuration for fascinate4g Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 03/18] ARM: dts: s5pv210: Add sleep GPIO configuration for galaxys Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 04/18] ARM: dts: s5pv210: Set keep-power-in-suspend for SDHCI1 on aries Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 05/18] ARM: dts: s5pv210: Disable pulls on GPIO i2c adapters for aries Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 06/18] ARM: dts: s5pv210: Add WM8994 support to aries boards Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 07/18] ARM: dts: s5pv210: Add FSA9480 support to Aries boards Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 08/18] ARM: dts: s5pv210: Add touchkey support to aries boards Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 09/18] ARM: dts: s5pv210: Add panel " Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 10/18] ARM: dts: s5pv210: Add remaining i2c-gpio adapters to aries Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 11/18] ARM: dts: s5pv210: Add si470x fmradio to galaxys Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 12/18] ARM: dts: s5pv210: Disable pull for vibrator ena GPIO on aries Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 13/18] ARM: dts: s5pv210: Add an ADC node Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 14/18] ARM: dts: s5pv210: Enable ADC on aries boards Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 15/18] ARM: dts: s5pv210: Assign clocks to MMC devices on aries Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 16/18] ARM: dts: s5pv210: Correct FIMC definitions Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 17/18] ARM: dts: s5pv210: Set MAX8998 GPIO pulls on aries Jonathan Bakker
2020-05-01 23:50 ` [PATCH v2 18/18] ARM: dts: s5pv210: Correct gpi gpio node name Jonathan Bakker
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200504151508.GA3205@kozik-lap \
--to=krzk@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=kgene@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-samsung-soc@vger.kernel.org \
--cc=robh+dt@kernel.org \
--cc=xc-racer2@live.ca \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).